EMAK RIDER Gebrauchsanweisung Seite 53

COMMANDS AND CONTROL INSTRUMENTS
3. Parking brake lever
This lever is to stop the machine from moving when it has been parked, and must
always be engaged before leaving the machine.
The brake is engaged by fully pressing the pedal (11 - 21) and moving the lever to
position «A». When you take your foot off the pedal it will be blocked by the lever in the
down position.
To disengage the parking brake, press the pedal again so that the lever returns to posi-
tion «B».
4. Key ignition switch
This key operated control has three positions:
«OFF»
«ON»
«START»
5. Pilot lamp and signal
This light comes on when the key (4) is in the «ON» position and remains constantly lit
while the machine is operating.
When it starts flashing this means that the engine is being prevented from starting (see
page 24).
The audible warning indicates that the grass-catcher is full.
6. Blade engagement and brake lever
This lever has two positions, as shown on the label:
Position «A»
Position «B»
If the blade is engaged when safety conditions have not been complied with, the
engine shuts down (see page 24).
On disengaging the blade (Pos. «A»), a brake is simultaneously activated which stops
it rotating in five seconds.
7. Cutting height adjusting lever
There are seven positions for this lever, shown as «1» to «7» on the label, which corre-
spond to various heights of between 3 and 8 cm.
To go from one height to another, move the lever sideways and put into one of the
seven notches.
means everything is switched off
activates all parts
engages the starter motor. On being released,
the key will automatically return to «ON» from this position.
= Blade disengaged
= Blade engaged
13
EN