Fitting The Steering Wheel; Fitting The Grass-Catcher - Emak Rider Gebrauchsanweisung

10
EN
WARNING!
!
safe handling and disposal.

3.3 FITTING THE STEERING WHEEL

Put the machine on a flat surface and straighten up
the front wheels.
Fit the steering wheel (1) onto the protruding shaft (2)
with the spokes directed towards the seat.
Line up the hole in the steering wheel hub with the
hole in the shaft and insert the pin supplied (3).
Push the pin in using a hammer, ensuring that it
comes completely through to the opposite side.
NOTE
or a screw-driver of the same size as the pin to push it in the last part.
3.4 FITTING THE SEAT
Fit the seat (1) onto the plate (2) using the screws
(3).

3.5 FITTING THE GRASS-CATCHER

First of all assemble the frame, joining the upper part (1), including the opening, to the
lower part (2), using the supplied nuts and screws (3) and following the indicated
sequence.
Position the angle supports (4) and (5), respecting the right (R ) and left (L ) sides,
and attach them to the frame using the four self-tapping screws (6).
Insert this frame into the canvas cover, ensuring that it is correctly positioned along the
base perimeter.
Hook all the plastic profiles to the frame tubes with the help of a screwdriver (7).
Insert the handle (8) into the holes of the canvas (9). Attach this to the frame using the
Follow the battery manufacturer's instructions regarding
To avoid damaging the steering wheel with the hammer, use an awl
UNPACKING AND ASSEMBLY
2
3
3
2 3 1
1