Cleaning And Storage - Emak Rider Gebrauchsanweisung

HOW TO USE THE MACHINE
IMPORTANT
– do not reverse the cables on the battery terminals;
– do not use the machine without its battery or damage may be caused to the
charging regulator;
– be careful to not cause short-circuits.
5.3.9 End of mowing
When you have finished mowing, disengage the
blade and ride the machine with the cutting deck
in the highest position.
Stop the machine, engage the parking brake and
turn off the engine by turning the ignition key to
«OFF».
When the engine is stopped, close the fuel cock
(1) (where fitted).
WARNING!
!
accelerator in the «SLOW» position for 20
seconds before stopping the engine.
WARNING!
!
tended!
IMPORTANT
position when the engine is not running.

5.4 CLEANING AND STORAGE

5.4.1 Cleaning
After each mowing, clean the outside of the machine, empty the grass-catcher and
shake it to remove residual grass and earth.
Clean the plastic parts of the body with a damp sponge using water and detergent,
taking care not to wet the engine, the electrical parts or the electronic card located
under the dashboard.
IMPORTANT
body and engine!
To avoid activating the protection device:
To avoid backfire, put the
Always take out the ignition key if leaving the machine unat-
To keep the battery charged, do not leave the key in the «ON»
Never use hose-nozzles or harsh detergents for cleaning the
25
EN
1