Menu Level 4: Default Setting; Menu Level 5: Temperature Unit Display - Dometic CoolAir RT780 Einbauanleitungen

Configuration of unit software
7.5

Menu level 4: Default setting

You can reset the parameters you set in configuration mode on menu
levels 1 to 3 to the default settings:
➤ Start configuration mode (chapter "Starting and ending configuration
mode" on page 20).
✓ The first digit of the display shows the menu level and the second and
third show the parameter which can be set.
➤ Press the + button three times to switch to menu level 4.
✓ The display shows
➤ Press the
✓
flashes in the display.
--
➤ Press the + button.
✓ The display shows
➤ Press the
✓ The parameters set in configuration mode are reset to the default
setting.
✓ You are now in menu level 4 and can use the + and – buttons to switch
between menu levels.
7.6

Menu level 5: Temperature unit display

The system can display the room temperature in °C or °F. This parameter
can be configured:
➤ Start configuration mode (chapter "Starting and ending configuration
mode" on page 20).
✓ The first digit of the display shows the menu level and the second and
third show the parameter which can be set.
➤ Press the + four times to switch to menu level 5.
➤ Press the
✓ The digits in the display flash until the parameter you entered is
confirmed.
➤ Use the + and – buttons to select the temperature unit that the system
should display.
➤ Press the
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 5 again and can use the + and – buttons to
switch between menu levels.
24
.
--
button, to reset the unit to the factory settings.
.
00
button to confirm your entry.
button to change the parameters.
button to confirm your entry.
CoolAir RT780
EN