Configuration Of Unit Software; Starting And Ending Configuration Mode - Dometic CoolAir RT780 Einbauanleitungen

Configuration of unit software

7 Configuration of unit software
Before you first start up the unit, the controls can be adapted to suit the
installation conditions. This must be done by the person installing the unit.
In configuration mode, the following unit software parameters must be set
at the control panel (fig. 8, page 6).
Menu
Parameter
level
1 Set temperature
2 Low voltage
cut-off
3 Operating mode
4 Default settings
5 Temperature unit
display
I
NOTE
Configuration mode can still be activated if the undervoltage protection
mechanism has switched off the unit and only residual voltage is
available.
7.1

Starting and ending configuration mode

The adjustable parameters can be changed in configuration mode:
➤ When using the
and – pressed until the compressor LED flashes.
✓ You are now in configuration mode.
✓ The display version (e. g. "3.1S") appears in the display for 2 seconds.
✓ The first digit of the display shows the menu level and the second and
third digits show the parameters which can be set, e.g.
level 1 and a set target value of 17 °C.
I
NOTE
If you make no entry on the control panel for 60 seconds, the unit quits
configuration mode and shuts down.
➤ Press the
20
Meaning
The unit starts at the temperature
defined here.
The battery monitor shuts down the unit
at the voltage defined here.
The unit starts with the operating mode
defined here.
Parameters 1 – 3 can be reset to the
default settings.
The temperature can be displayed in °C
or °F.
button to switch on the unit, hold both buttons +
button to quit configuration mode.
CoolAir RT780
Default
setting
20 °C (68 °F)
Characteristic
figure 4 =
22,8 V
0 = Automatic
mode
--
°C
for menu
1.17
EN