Milk Circuit Cleaning Cycle - Faema Barcode New Touch Gebrauch Und Installation

Level 1
These procedures are to be performed at the end of the
work day or when the machine sends a message (see
paragraph "Customer programming – Services hour menu).
When the machine sends a message, the screen displays
"EXECUTE WASHING MILK CIRCUIT" accompanied by
an acoustic signal.
The message and signal will continue until the procedure
is performed or up until the end of the timeout (60').
Please follow these instructions for the washing process:
1
After the machine sends the
message.
Press the key PRG (29)
4
The following will appear on the
display:
24 29
7
Place approximately 0.7 liters of
cold water in a container and add a
dose of liquid detergent (see product
instructions).

MILK CIRCUIT CLEANING CYCLE

2
1
Raise the dispensing nozzle (1).
.
5
Press the washing key (26)
until the
WASH" appears, as shown below:
PRESS WASH
Group Washing
Milk Washing
Soluble Washing
26
8
Remove the intake tube from the
milk container and immerse it in the
solution (water-detergent).
MILK IS A FOOD PRODUCT THAT REQUIRES
MAXIMUM HYGIENE! NOT PERFORMING
REGULAR AND DAILY WASHING CYCLES
CAUSES OCCLUSIONS, WHICH CAN MAKE THE
CIRCUIT BREAK AND CAUSE LEAKS.
Therefore, please scrupulously follow the washing
instructions.
3
1
Place the washing container sotto il
6
message "PRESS
cursor is on the group washing line, or
when the MILK WASHING option is
pressed directly on the Touch Screen.
The message below will appear on
the display:
22 EN
under the dispensing nozzle (1).
The washing cycle starts if the key
PRG (29) is pressed when the
START WASHING
Insert milk pipe in
the container with
water and detergent
as per instructions