Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning And Maintenance - Faema E61 Handbuch

Vorschau ausblenden Andere Handbücher für E61:
Inhaltsverzeichnis

Werbung

English

Cleaning and maintenance

Cleaning the dispenser units
This procedure should be carried out at the end of the working
day on all dispenser units.
1) Clean the underpan gasket with a brush.
2) Fit the blank ring into the filter holder.
3) Pour in the filter holder the content of a sachet or a measure of
detergent powder.
4) Connect the filter carrier to the group and perform a few cycles.
5) Remove the filter carrier, clean the spout with a sponge.
6) Rinse by dispensing water from each group for about 30".
Filter Holders
1) Pour 1 litre of cold water and a dose of detergent into a suitable
receptacle.
2) Remove the filters from the filter holders.
3) Leave the filters and filter holders in the solution for at least two
hours.
4) Remove any residues with a sponge and rinse in plenty of cold
water.
5) Refit the filters in the filter holders, making sure that the filter fixing
spring is in the correct position.
Steam and hot water dispensing pipe
Using a clean sponge, wash with hot water removing any organic residue
present. Rinse carefully.
To clean the inside of the steam nozzle, follow these steps:
Turn the nozzle towards the cup tray and carefully activate steam
dispensing at least once.
Drip pan
Remove the drip plan and complete the cleaning with running water
ATTENTION
!
When the machine has not been used for more than 8
hours, and in any case once a day, the internal
components must be washed before use, in
accordance to the following instructions:
Supply Groups
Insert the filter carriers into the groups (without coffee) and dispense
from each group for one minute.
Discharge tank
At the end of the working day, pour a jug of hot water into the discharge
tank, removing any organic residue present.
Bodywork
Use a soft cloth and cleaning products WITHOUT ammonia or
abrasives, removing any organic residue present in the work area.
N.B. Do not spray liquids into the panel slots.
Hot water
Dispense hot water repeatedly (using the relative command)
until at least 6 liters of water have been dispensed from the 2-
group machine, and 9 liters from the 3-group machine.
Steam
Dispense steam from the steam pipe for about one minute,
using the relative commands.
English

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

E61 3 grE 61 2 gr

Inhaltsverzeichnis