Yamaha RX-V2700 Bedienungsanleitung Seite 114

REMOTE CONTROL FEATURES
1
Set the operation mode selector to SOURCE
and then press an input selector button or
to select the input area you want to set up.
AMP
SOURCE
TV
2
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object.
The library name (ex. L;DVD) and the name of the
selected input area (ex. DVD) appear alternately in
the display window on the remote control.
LEARN
y
• You can set a remote control code of a different type of
component to an input area. Press l / h repeatedly to
change the library (component category).
Library choices: L;DVD, L;DVR, L;LD, L;CD, L;CDR,
L;MD, L;TAP (tape), L;TUN (tuner),
L;AMP, L;TV, L;CAB (cable),
L;SAT (satellite), L;VCR
• If you want to setup for another input area, press the input
, or press SELECT k / n repeatedly to
selector button or
select the input area.
Notes
• Be sure to press and hold LEARN for at least 3 seconds,
otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 2.
3
Press ENTER.
The four-digit code set for the selected component
appears in the display window.
Note
"0000" appears in the display window if no code has been set.
112
En
NET/USB
PHONO TUNER CD MULTI CH IN
V - AUX/DOCK
CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR 2 DVD
4
Press the numeric buttons to enter the
four-digit remote control code for the
component you want to use.
For a complete list of available remote control codes,
refer to "LIST OF REMOTE CONTROL CODES" at
the end of this manual.
CLASSICAL LIVE/CLUB
1
STEREO SUR. DECODE
5
9 0
5
Press ENTER to set the number.
"OK" appears in the display window on the remote
control if setting was successful.
"NG" appears in the display window on the remote
control if the setting was unsuccessful. In this case,
start over from step 3.
y
If you continuously want to set up another code for another
component, press the input selector button, or
SELECT k / n repeatedly to select the component, then
repeat steps 2 through 5.
6
Press LEARN again to exit from the setup
mode.
LEARN
7
Press p or AV POWER to confirm whether
you can control your component using the
remote control.
y
If operation is not possible and the manufacturer of your
component has more than one code, try each of them until
you find the correct one.
Notes
• "ERROR" appears in the display window on the remote control
if you press a button not indicated in the respective step, or
when you press more than one button simultaneously.
• The supplied remote control does not contain all possible codes
for commercially available audio and video components
(including YAMAHA components). If operation is not possible
with any of the remote control codes, program the new remote
control function using the learn feature (see "Programming
codes from other remote controls") or use the remote control
supplied with the component.
• Functions programmed using the learn feature take priority over
remote control code functions.
ENTERTAIN MOVIE
2 3 4
SELECT EXTD SUR.
6 7 8
POWER
or
AV