Programming Codes From Other Remote Controls - Yamaha RX-V2700 Bedienungsanleitung

Programming codes from other
remote controls
You can program remote control codes from other remote
controls. Use the learn feature if you want to program
functions not included in the basic operations covered by
the remote control codes, or an appropriate remote control
code is not available. You can program the function of
other remote control to the buttons in the highlighted areas
in the following illustration. The buttons can be
programmed independently for each input area.
POWER POWER STANDBY POWER
TV AV
NET/USB AUDIO SEL SLEEP
PHONO TUNER CD MULTI CH IN
V-AUX/DOCK CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR 2 DVD
SELECT
AMP
+ + +
SOURCE
TV VOL CH VOLUME
TV
– – –
TV MUTE TV INPUT MUTE
Note
The remote control transmits infrared rays. If the other remote
control also uses infrared rays, this remote control can learn most
of its functions. However, you may not be able to program some
special signals or extremely long transmissions. Refer to the
operating instructions for the other remote control.
1
Set the operation mode selector to SOURCE
and then press an input selector button or
to select an input area.
AMP
SOURCE
V - AUX/DOCK
TV
Note
Make sure that the operation mode selector is set to SOURCE.
When you set the operation mode selector to AMP and program a
remote control codes from other remote controls, the
programmed key cannot operate the amplifier function of this
unit.
PRESET/CH
LEVEL SET MENU PURE DIRECT
TITLE MENU
SRCH MODE
ENTER AUDIO
A/B/C/D/E
STRAIGHT
RETURN DISPLAY
MEMORY EFFECT
CLASSICAL LIVE/CLUB ENTERTAIN MOVIE
1 2 3 4
STEREO SUR. DECODE SELECT EXTD SUR.
5 6 7 8
1 MEMORY 2 NIGHT ENHANCER
0 + 10
9 ENT
FREQ/TEXT EON MODE PTY SEEK START
NET RADIO USB
REC
PC/MCX
OFF ON MACRO LEARN CLEAR RENAME
NET/USB
PHONO TUNER CD MULTI CH IN
CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR 2 DVD
2
Place this remote control about 5 to 10 cm
apart from the other remote control on a flat
surface so that their infrared transmitters are
aimed at each other.
5 to 10 cm
3
Press LEARN using a ballpoint pen or similar
object.
"LEARN" and the name of the selected input area
(ex. "DVD") appear alternately in the display window
on the remote control.
LEARN
Notes
• Do not press and hold LEARN. If you hold it down for
more than 3 seconds, the remote enters the remote control
code setting mode.
• If you do not complete each of the following steps within
30 seconds, the learning mode will be automatically
canceled. In this case, start over from step 3.
4
Press the button for which you want to
program the new function.
"LEARN" appears in the display window on the
remote control.
REMOTE CONTROL FEATURES
Other remote control
113
En