Yamaha RX-V2700 Bedienungsanleitung Seite 133

Problem
No picture. The output and input for the picture are
connected to different types of video
jacks.
Non-standard video signals are input.
Short message "Short Message" is set to "OFF".
displays do not
"Wall Paper" is set to "None".
appear in the video
monitor.
"Conversion" is set to "Off".
The signals input at the HDMI IN1,
HDMI IN2 or HDMI IN3 jack are being
output at the HDMI OUT jack.
Video signals in the progressive format or
HDTV video signals are being input.
The sound suddenly The protection circuitry has been activated
goes off. because of a short circuit, etc.
The sleep timer has turned off this unit.
The sound is muted.
Sound is heard from Incorrect cable connections.
the speaker on one
side only.
Incorrect settings in "Speaker Level".
Only the center When playing a monaural source with a
speaker outputs
CINEMA DSP program, the source signal
substantial sound. is directed to the center channel, and the
front and surround speakers output effect
sounds.
No sound is heard "Center" in "Speaker Set" is set to
from the center "None".
speaker.
One of the HiFi DSP programs (except for
"7ch Stereo") has been selected.
No sound is heard The sound field programs are turned off.
from the presence
You are using a source or program
speakers.
combination that does not output sound
from all channels.
No sound is heard "Surround" in "Speaker Set" is set to
from the surround
"None".
speakers.
This unit is in the "STRAIGHT" mode
and a monaural source is being played
back.
No sound is heard "Bass Out" in "Speaker Set" is set to
from the subwoofer.
"Front" when a Dolby Digital or DTS
signal is being played.
"Bass Out" in "Speaker Set" is set to
"SWFR" or "Front" when a 2-channel
source is being played.
The source does not contain low-
frequency signals.
Cause
Set "Conversion" to "On" or connect your source
components in the same way as you connect your
video monitor to this unit.
Set "Short Message" to "On".
Set "Wall Paper" to "Yes" or "Gray".
Set "Conversion" to "On".
Check that the speaker impedance setting is correct.
Check that the speaker wires are not touching each
other and then turn this unit back on.
Turn on this unit, and play the source again.
Press MUTE or VOLUME +/– on the remote control
to resume audio output.
Connect the cables properly. If the problem persists,
the cables may be defective.
Adjust the "Speaker Level" settings.
Set "Center" to "Small" or "Large".
Try another sound field program.
Press STRAIGHT to turn them on.
Try another sound field program.
Set "Surround" to "Small" or "Large".
Press STRAIGHT on the front panel so that
"STRAIGHT" disappears from the front panel
display.
Set "Bass Out" to "SWFR" or "Both".
Set "Bass Out" to "Both".
TROUBLESHOOTING
Remedy
See
page
93
94
95
93
33, 126
—
—
43
16
100
96
47
51
40
97
51
98
98
131
En