Auto Setup; Using Auto Setup - Yamaha Rx-V2700 Bedienungsanleitung

This unit employs the YPAO (YAMAHA Parametric Room Acoustic Optimizer) technology which lets you avoid
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening
environment.

Using Auto Setup

Once you have connected the supplied optimizer
microphone to the OPTIMIZER MIC jack on the front
panel and have placed it in a suitable location in your
listening room, run "Auto Setup" in the GUI screen.
Notes
• Connect a video monitor to run "Auto Setup" (see page 23).
• Be advised that it is normal for loud test tones to be output
during the "Auto Setup" procedure.
• To achieve the best results, make sure the room is as quiet as
possible while the "Auto Setup" procedure is in progress. If
there is too much ambient noise, the results may not be
satisfactory.
y
• If an error occurs during the "Auto Setup" procedure and an
error or warning message appears in the GUI screen or in the
front panel display, see the "Auto Setup" section in
"TROUBLESHOOTING" on pages 138 and 139 for a complete
list of error and warning messages and proper remedies.
• The initial setting for each parameter is indicated in bold.
• If the volume level and the crossover frequency of your
subwoofer can be adjusted, set the volume level to about half
way (or slightly less) and set the crossover frequency to the
maximum.
+ +
TV VOL CH VOLUME
– –
TV MUTE TV INPUT MUTE
PRESET/CH
LEVEL SET MENU
TITLE MENU
SRCH MODE
ENTER
A/B/C/D/E
RETURN DISPLAY
MEMORY

AUTO SETUP

4
AMP
+
SOURCE
TV
–
4,13
PURE DIRECT
AUDIO 5-12
STRAIGHT
EFFECT
1
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
AUDIO TONE REC OUT/
ZONE2
SELECT CONTROL A/B/C/D/E PRESET/TUNING
STRAIGHT
MULTI ZONE
EFFECT
YPAO SILENT CINEMA S VIDEO
PROGRAM OPTIMIZER
MIC PHONES
2
Place the optimizer microphone at your
normal listening position on a flat level
surface with the omni-directional
microphone heading upward.
Optimizer microphone
y
It is recommended that you use a tripod (etc.) to affix the
optimizer microphone at the same height as your ears would be
when you are seated in your listening position. You can use a 6
mm diameter screw to fix the optimizer microphone to a tripod
(etc.).
AUTO SETUP
PRESET/ MEMORY TUNING
FM/AM ENHANCER
TUNING MAN'L/AUTO FM MODE NIGHT
EDIT
ZONE ON/OFF ZONE CONTROLS
ZONE 2 ZONE 3
VIDEO L AUDIO R OPTICAL
VIDEO AUX USB
Omni-directional
microphone
35
En