Yamaha RX-V2700 Bedienungsanleitung Seite 140

TROUBLESHOOTING
Auto Setup
Before Auto Setup
Error message
Connect MIC!
Unplug Phones!
No Setup Menu!
Memory Guard!
During Auto Setup
Error message
E01:No Front SP
E02:No Sur. SP
E03:No PRNS SP
E04:SBR->SBL
E05:Noisy
E06:Check Sur.
E07:No MIC
E08:No Signal
E09:User Cancel
E10:Internal Err.
138
En
Cause
Optimizer microphone is not connected.
Headphones are connected.
All setup menu are set to "Skip".
"Memory Guard" is set to "On".
Cause
Front L/R channel signals are not detected.
A surround channel signal is not detected.
A presence channel signal is not detected.
Only right surround back channel signal is
detected.
Background noise is too loud.
Surround back speakers are connected,
though surround L/R speakers are not.
The optimizer microphone was unplugged
during the "Auto Setup" procedure.
The optimizer microphone does not detect
test tones.
The "Auto Setup" procedure was cancelled
due to user activity.
An internal error occurred.
Remedy
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
Unplug the headphones.
Set the desired menu item to "Check".
Set "Memory Guard" to "Off".
Remedy
Check the front L/R speaker connections.
Check the surround speaker connections.
Check the presence speaker connections.
Connect the surround back speaker to the
LEFT SURROUND BACK SPEAKERS
terminal if you only have one surround
back speaker.
Try running "Auto Setup" in a quiet
environment.
Turn off noisy electric equipment like air
conditioners or move them away from the
optimizer microphone.
Connect surround speakers when you use
surround back speakers.
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
Check the microphone setting.
Check the speaker connections and
placement.
Run "Auto Setup" again.
Run "Auto Setup" again.
See
page
35
—
36
105
See
page
16
16
16
16
—
—
16
35
35
16
35
35