NOTE
►
Turn the additional handle
locking positions depending on your working
position. Undo and lock the additional han-
dle
as described previously.
Depth stop
♦
Push the locking button for the depth stop
and keep it pushed in.
♦
Insert the depth stop
handle
.
♦
Ensure that the toothing on the depth stop
facing downwards.
♦
Pull the depth stop
between the tip of the drill and the tip of the
depth stop with the required drilling depth.
♦
Release the locking button for the depth stop
to lock the depth stop
Fitting/removing a tool
WARNING!
►
Switch the appliance off and remove the
power plug before starting any work on the
appliance.
Fitting a tool:
♦
Before fitting a tool, grease the tool holder
lightly with machine grease.
♦
Place the tool in the tool holder
rotates until it locks automatically.
♦
Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.
Removing a tool:
♦
To release the tool, pull the locking collar
backwards.
Quick-release chuck for round shaft
drill bits
WARNING!
Do not use the quick-release chuck
►
for hammer drilling or chiselling!
│
GB │ IE
■
16
into the various
into the additional
out until the distance
.
so that it
♦
Set the function selector switch
symbol .
Inserting the quick-release chuck for round
shaft drill bits:
♦
Place the quick-release chuck
holder
so that it rotates until it locks automat-
ically.
♦
Check that the tool is properly locked by pulling
it.
Removing the quick-release chuck for round
shaft drill bits:
is
♦
To remove the quick-release chuck
locking collar
quick-release chuck
Use
Select operating mode
Function selector:
♦
Press and hold the release button
function selector switch
selector switch
engages at the arrow mark:
Function
Drilling/screwing
Hammer drilling
Chiselling
Chisel position adjust-
ment
Adjusting chisel position:
You can rotate the tool to the required position for
chiselling using this function.
♦
Turn the function selector switch
♦
Turn the tool in the tool holder
position.
♦
Turn the function selector switch
for the chiselling function.
to the drill
in the tool
, pull the
backwards and remove the
.
on the
. Turn the function
so that the required symbol
Symbol
to position .
to the required
to position
PBH 800 A1