Depth Stop; Inserting / Removing Tools; Quick-Release Chuck For Round Shaft Drills; Setting The Function With The Function Selector Switch - Parkside PBH 1050 B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Start-up

Depth stop

Open the wing screw
Insert the depth stop
handle
Make sure that the toothing on the depth stop
is pointing downwards.
Pull the depth stop
so that the distance between the tip of the drill
and the tip of the depth stop corresponds to
the desired drilling depth.
Firmly tighten the wing screw

Inserting / removing tools

Inserting tools:
Lightly grease the tool holder
ing the tool.
To insert, pull back the locking sleeve
insert the tool.
Release the locking sleeve
tool holder. Pull the tool to ensure that it is firm-
ly locked in place. The tool has some radial play
inherent in the system.
Removing tools:
To remove the tool pull back on the locking
sleeve
10
Quick-release chuck for
round shaft drills
chuck for round shaft drills for hammer drilling or
chiseling applications!
Set the function selector switch
symbol .
Attaching the quick-release chuck for
round shaft drills:
To attach the additional chuck for round shaft
drills (also see Fig. A) pull back the locking
sleeve
10
10 GB/IE
Downloaded from www.Manualslib.com
.
1
in the additional
11
.
7
out as far as necessary
11
1 .
before insert-
8
. This locks the
10
.
Do not use the quick-release
6
and insert the additional chuck.
manuals search engine
Release the locking sleeve
holder. Pull the tool to ensure that it is firmly
locked in place.
Removing the quick-release chuck for
round-shaft drills:
11
To remove the additional chuck pull back the lock-
ing sleeve
Inserting tools:
device off and unplug from the mains socket before
performing any work on the device.
Setting the function with the
function selector switch
Press and hold the release button for the function
and selector switch
10
switch
to the arrow.
The functions are marked as follows:
Function
Drilling / screwing
Hammer drilling
Chiseling
Chisel position
adjustment
Adjusting the chisel position:
to the drill This function allows you to turn the tool to the nec-
essary position for chiseling (also see Fig. C, D).
Turn the function selector switch
.
Turn the tool inside the tool holder
necessary position.
To chisel, turn the function selector switch
. This locks the tool
10
and remove the additional chuck.
10
RISK OF INJURY! Switch the
and turn the function selector
6 a
until the desired symbol locks in next
6
Symbol
6
to position
to the
8
to .
6