Attention! Service Lines; Original Ancillaries / Accessories; Preparing For Use; Assembling The Additional Handgrip - Parkside PEBH 1010 Bedienungs- Und Sicherheitshinweise

General safety advice for electrical power tools / Preparing for use
footing and balance, hold the hammer drill
firmly with both hands and use the auxiliary
handle .
9
J
Wear safety glasses and a
dust mask! POISONOUS
DUSTS! Working with harmful / noxious dusts
represents a risk to the health of the person op-
erating the device and to anyone near the
working area.
J
Do not drill any material containing
asbestos. Asbestos is a known carcinogen.
J
Do not allow the ventilation slots to become
covered while the device is operating. Do not
insert any objects into the ventilation slots.

attention! Service lines!

Q
WarNING! Take steps to ensure that
you do not hit upon any service lines
(electricity, gas, water) when working
with electrical appliances. Check, if need be
with a service line detector, before you start to cut
or bore into a surface.

Original ancillaries / accessories

Q
J
Use only the ancillaries and accessories
that are detailed in the operating in-
structions. The use of ancillaries and acces-
sories other than those recommended in the
operating instructions could lead to an increased
risk of personal injury for you.

Preparing for use

Q
Note the mains voltage! The voltage of the
mains socket must match that shown on the rating
plate on the device (Devices marked with 230 V ~
can also be operated at 220 V ~ ).
10 GB
assembling the additional
Q
Handgrip
Note: For safety reasons this device may only be
used when the additional handgrip
assembled (see also Fig. D, E).
j
Attach the additional handgrip
neck and turn it in an anticlockwise direction
until it is tight.

Depth stop

Q
j
Setting the depth stop
dle .
9
j
Set the required drilling depth by sliding the
depth stop .
10

Inserting / removing Tools

Q
Inserting a Tool:
j
Before inserting the tool, apply a small amount
of grease to the tool holder
j
In order to insert the tool, pull the locking / un-
locking cap to the rear and insert the tool.
3
j
Release the locking / unlocking cap
locks the tool holder in place. Pull the tool to
ensure that it is firmly locked in place. The tool
has some radial play inherent in the system.
removing a Tool:
j
In order to remove the tool, pull the locking /
unlocking cap to the rear.
3
quick action chuck
Q
for round-shank drills
WarNING! Do not use the round-shank drill
for hammer drilling or chiselling work!
j
Set the function selector switch
symbol .
is correctly
9
to the spindle
9
in the auxiliary han-
10
.
1
. This
3
to the drill
8