Before use
Charging the battery pack (see fig . A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack
to the charger .
■
Never charge the battery pack
ambient temperature is below 10°C or above
40°C .
♦
Connect the battery pack
battery charger
♦
Insert the power plug into the socket . The control
LED
lights up red to indicate that the appli-
ance is charging .
♦
The green LED
indicates that the charging
process is complete and the battery pack
ready .
♦
Push the battery pack
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦
Push the rotation direction switch
middle position (lock) .
Allow the battery pack
handle .
Removing the battery pack:
♦
Press the release button
battery pack
.
Checking the battery charge level
♦
Press the battery charge level button
check the charge level of the battery .
The status/remaining charge will be shown on
the battery display LED
♦
RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
PKHAP 20-Li A1
from or connect it
when the
to the high-speed
(see fig . A) .
into the appliance .
into the
to click into the
and remove the
to
as follows:
Use
Additional handle
NOTE
►
For safety reasons, you should never use this
appliance without the additional handle
attached .
♦
Remove the additional handle
a clockwise direction (see fold-out page) .
♦
Turn the additional handle
position .
♦
Fix the additional handle
by turning it anticlockwise .
Depth stop
♦
Push the locking button for the depth stop
is
and keep it pushed in .
♦
Insert the depth stop
handle
.
♦
Ensure that the toothing on the depth stop
facing downwards .
♦
Pull the depth stop
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth .
♦
Release the locking button for the depth stop
to lock the depth stop .
Tool/chuck:
♦
Place the tool in the tool holder
rotates until it locks automatically .
♦
Check that the tool is properly locked by pulling
it . The system has radial play because of the
design .
Removing a tool:
♦
Pull the locking collar
remove the tool .
by turning it in
to the desired
in the new position
into the additional
out until the distance
so that it
backwards and
GB │ MT
│
35
is
■