Original accessories / auxiliary
equipment
■
Only use the accessories and additional
equipment which are specified in the
operating instructions and are compatible
with the appliance.
Operation
Additional handle
NOTE
►
For safety reasons, you should only use this
appliance with the additional handle
attached .
►
The appliance is fitted with an LED
This lights up red as soon as the appliance is
connected to the power supply .
This indicates that the appliance is connected
to the power and that it will turn on immedi-
ately if the ON/OFF switch is pressed
♦
The position of the additional handle
adjusted . Turn the wing screw
and swivel the additional handle
desired position .
♦
Then tighten the wing screw
Depth stop
♦
Open the wing screw
♦
Insert the depth stop
handle
.
♦
Ensure that the toothing on the depth stop
facing upwards and downwards .
♦
Pull the depth stop
distance between the tip of the drill and the tip
of the depth stop to correspond with the
required drilling depth .
♦
Retighten the wing screw
■
26
│ GB │ MT
.
.
can be
anti-clockwise
into the
again .
.
into the additional
out far enough for the
afterwards .
Fitting/removing a tool
WARNING!
►
Switch the appliance off and remove the
power plug before starting any work on the
appliance .
Fitting a tool:
♦
Before fitting a tool into the tool holder
grease it lightly .
♦
To insert, pull the locking collar
and insert the tool .
♦
Release the locking collar
tool holder
locked by pulling it . The system has radial play
because of the design .
Removing a tool:
♦
To remove the tool, pull the locking collar
backwards .
Quickrelease chuck for round shaft
drill bits
WARNING!
►
Do not use the quick-release chuck
hammer drilling or chiselling!
♦
Set the function selector switch
symbol .
Inserting the quick-release chuck for round
is
shaft drill bits:
♦
To insert the quick-release chuck
fig . A) pull the locking collar
Insert the quick-release chuck
♦
Release the locking collar
tool holder
locked by pulling it .
Removing the quick-release chuck for round
shaft drill bits:
♦
To remove the quick-release chuck
locking collar
quick-release chuck
backwards
. This locks the
. Check that the tool is properly
to the drill
(see also
backwards .
.
. This locks the
. Check that the tool is properly
backwards and remove the
.
PBH 1050 B2
,
for
, pull the