Appliance-specifi c safety instructions
for hammer drills
■
■
Use auxiliary handle(s), if supplied with the
tool. Loss of control can cause personal injury.
■
Hold power tool by insulated gripping surfac-
es, when performing an operation where the
cutting accessory may contact hidden wiring
or its own cord. Cutting accessory contacting
a "live" wire may make exposed metal parts of
the power tool "live" and could give the opera-
tor an electric shock.
■
WARNING! TOXIC DUST!
►
Working with harmful/toxic dusts results in
health hazards for the person operating the
appliance and for other persons in the area.
■
ATTENTION – SERVICE LINES! DANGER!
Take steps to ensure that you do not hit any
service lines (electricity, gas, water) when
working with the electric tool. If necessary,
check with a service line detector before you
start to cut or drill into a surface.
Original accessories/additional
equipment
■
Only use the accessories and additional
equipment that are specifi ed in the operat-
ing instructions and are compatible with the
appliance.
Initial operation
Additional handle
NOTE
►
For safety reasons, you should only use this
appliance with the additional handle
attached.
♦
Remove the additional handle
clockwise direction.
♦
Turn the additional handle
position.
PBH 1500 A1
Downloaded from
www.Manualslib.com
Wear ear protectors. Exposure to
noise can cause hearing loss.
Wear a dust mask.
by turning it
to the desired
manuals search engine
♦
Fix the additional handle
by turning it anti- clockwise.
Depth stop
♦
Open the wing screw
♦
Insert the depth stop
handle
.
♦
Ensure that the toothing on the depth stop
facing upwards.
♦
Pull the depth stop
distance between the tip of the drill and the tip
of the depth stop to correspond with the
required drilling depth.
♦
Re-tighten the wing screw
Tool/chuck:
♦
Pull the locking sleeve
the tool/chuck
in the tool holder
♦
Release the locking sleeve
holder. Check that the tool is properly locked by
pulling it. The system has radial play because of
the design.
Removing tool/chuck:
♦
Pull the locking collar
NOTE
Tighten the drill in the wheel-rim chuck
same time. To do this, apply the chuck key to all
the 3 positions on the wheel-rim chuck
tighten the tool (e.g. drill) at the same time.
WARNING!
►
Do not use the wheel-rim chuck
mer drilling or chiselling!
in the new position
.
into the additional
is
out far enough for the
afterwards.
backwards and insert
.
. This locks the
on the tool backwards.
at the
and
for ham-
5
GB