Operation; Additional Handle; Depth Stop; Fitting/Removing A Tool - Parkside PBH 800 A1 Originalbetriebsanleitung

Operation

Additional handle

NOTE
► For safety reasons, you should only use this
appliance with the additional handle
attached.
♦ The gripping position of the additional handle
can be varied.
Turn the wing screw
the additional handle
little way.
♦ Turn the additional handle
position.
♦ Now, slide the locking positions on the addi-
tional handle over the two locking pins on
the spindle of the appliance.
♦ Retighten the wing screw
turning it in a clockwise direction.
NOTE
► Turn the additional handle
locking positions depending on your working
position. Undo and lock the additional han-
dle as described previously.

Depth stop

♦ Undo the wing screw
♦ Insert the depth stop
handle .
♦ Ensure that the toothing on the depth stop
facing downwards.
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop with the required drilling depth.
♦ Retighten the wing screw
│ GB │ MT
■16
anticlockwise and pull
off the appliance a
to the desired
afterwards by
into the various
.
into the additional
out until the distance
afterwards.

Fitting/removing a tool

WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance.
Fitting a tool:
♦ Before fitting a tool, grease the tool holder
lightly with machine grease.
♦ To insert, pull the locking collar
and insert the tool.
♦ Release the locking collar
tool holder
locked by pulling it. The system has radial play
because of the design.
Removing a tool:
♦ To release the tool, pull the locking collar
backwards.
Quick-release chuck for round shaft
drill bits
WARNING!
► Do not use the quick-release chuck
hammer drilling or chiselling!
♦ Set the function selector switch
symbol .
Inserting the quick-release chuck for round
shaft drill bits:
♦ To insert the quick-release chuck
fig. A) pull the locking collar
is Insert the quick-release chuck
♦ Release the locking collar
tool holder
locked by pulling it.
Removing the quick-release chuck for round
shaft drill bits:
♦ To remove the quick-release chuck
locking collar
quick-release chuck
backwards
. This locks the
. Check that the tool is properly
to the drill
(see also
backwards.
.
. This locks the
. Check that the tool is properly
backwards and remove the
.
PBH 800 A1
for
, pull the