Changing The Dust Filter On The Outer Cabin; Changing The Dust Filter On The Inner Cabin; Changing The Dust Filter Behind The Driver's Seat; Cleaning - Kärcher MIC 50 Handbuch

5. Open the locks on the air filter housing.
6. Remove the air filter housing.
7. Pull out the filter cartridge and safety cartridge.
8. Clean the air filter housing on the inside.
9. Knock the dust out of the filter cartridge on a hard sur-
face.
Do not blow out the filter cartridge with compressed air.
10.Check that the filter cartridge and sealing surfaces are
clean and undamaged.
Renew a heavily soiled or damaged filter cartridge.
11.Renew the safety cartridge.
Do not re-use a used safety cartridge.
12.Insert the cleaned filter cartridge.
13.Fit the air filter housing.
14.Close the lock on the air filter housing.
15.After assembly, pivot the complete air filter unit inwards
and tighten it using the wing screw.
16.Attach the right-hand side cover.

12.7.18Changing the dust filter on the outer cabin

Cover
1
Dust filter
2
Note
Fine filter filter grade F8 (available as option)
1. Unscrew the 6 screws for the cover.
2. Remove the cover.
3. Take out the dust filter.
4. Blow out the slightly contaminated dust filter using com-
pressed air (reduced pressure). Renew severely con-
taminated dust filter.
5. Insert the new or cleaned filter.

12.7.19Changing the dust filter on the inner cabin

Clamping lever
1
Cover
2
Dust filter
3
Note
Fine filter filter grade F8 (available as option)
1. Release the clamping lever.
2. Remove the cover in an upward direction.
3. Take out the dust filter.
4. Replace the dust filter.
Check that the seal and dust filter are correctly fitted
during installation.
5. Attach the cover.
6. Actuate the clamping lever.
12.7.20Changing the dust filter behind the driver's
seat
Driver's seat
1
Dust filter
2
Air recirculation lever
3
1. Push the driver's seat completely forwards.
2. Take out the dust filter.
3. Replace the dust filter.
4. Push the driver's seat backwards.

12.8 Cleaning

CAUTION
Risk of injury and damage
Always secure the tipping mechanism.
1. Park the vehicle on a level surface.
2. Switch off the ignition and remove the ignition key.
3. Apply the parking brake.
4. Switch off the main switch.

12.8.1Cleaning the vehicle

Clean the vehicle daily after finishing work.
CAUTION
Risk of damage through incorrect cleaning
The articulated joint, tyres, radiator fins, hydraulic hoses
and valves, seals, electrical and electronic components
must not be cleaned using a high-pressure cleaner.
Observe the respective safety regulations when cleaning
the vehicle with a high-pressure cleaner.
Do not use aggressive cleaning agents.
Wash the vehicle only when the engine is switched off to
protect the air filter.
1. To avoid a risk of fire, check the vehicle for escaping oil
and fuel. Have leaks repaired by Customer Service.
2. Clean all plant residues and oil from the engine, muffler,
battery and fuel tank to avoid a risk of fire.
3. If necessary, clean the engine with a brush, compressed
air or with low water pressure if necessary.
4. Clean the wheel mudguards.
English 89