Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety devices
Brush protective cover
Illustration B
The protective cover prevents the operator or persons in
the vicinity from being injured by flung particles.
Symbols on the device
Warning of flying objects.
Keep other persons away from the work
area.
Wear suitable hearing protection and
safety goggles when operating the de-
vice.
Protect the device from rain and spray
water.
For users up to 177 cm tall.
For users taller than 178 cm.
For use under objects (e.g. benches).
Direction of rotation for opening the bris-
tle strip locking cover.
Direction of rotation for closing the bris-
tle strip locking cover.
Description of the device
See graphics page for illustrations
Illustration A
Rotating nylon brush
1
Pivoting cleaning head
2
Pivoting cleaning head unlocking button
3
Telescoping handle
4
Second handle
5
Telescoping handle unlocking button
6
Trigger lockout button
7
Handle
8
Trigger
9
Mount for 18 V Battery Power battery pack
10
Battery pack unlocking button
11
Type plate
12
Brush protective cover
13
Guide aid with bristle strip locking cover
14
1. Push the pipe provided with the chamfered side into
the motor housing.
The pipe latches audibly into place.
ATTENTION
Risk of damage
The handle is pre-installed and set to the shortest tele-
scopic length. Do not change the setting until the tele-
scoping handle is completely installed.
2. Insert the upper tube section into the mount on the
handle until it audibly latches into place.
Illustration C
3. Fit the power cable into the cable duct in the tele-
scoping handle from the bottom to the top.
Illustration D
4. Push the second handle into the mount until it audi-
bly latches into place.
Illustration E
5. Push the protective cover into the mount until it au-
dibly latches into place.
Illustration F
6. Screw open the handle lock of the bristle strip holder
in a clockwise direction and remove it.
Illustration G
7. Join the bristle strip into a crown by snapping the
ball into the recess.
Illustration H
8. Place the bristle crown into the holder.
Illustration I
9. Put on the guide aid including the bristle strip locking
cover and screw closed in an anti-clockwise direc-
tion.
Illustration J
Adjusting the device
Adjusting the telescoping handle
You can adjust the length of the device to suit your re-
quirements.
1. Press the unlocking button.
2. Adjust the telescoping handle as desired.
Illustration K
Adjusting the cleaning head
You can adjust the angle of the cleaning head to suit
your requirements. The device has the following setting
options:
For users up to 177 cm tall.
For users taller than 178 cm.
For use under objects (e.g. benches).
1. Press the cleaning head unlocking button.
2. Adjust the cleaning head.
Illustration L
English
Assembly
Initial startup
11
Werbung
Kapitel
Fehlerbehebung
