4-Point Mount (Optional); Fitting The Attachment On The 4-Point Mount; Detaching The Attachment On The 4-Point Mount; Front Mounting Frames - Kärcher MIC 50 Handbuch

2. Connect the lower link to the attachment.
3. Fix the attachment in place using 2 bolts and secure the
bolts with locking pins.
4. Connect and secure the top link to the attachment.
Observe the following description pertaining to correct /
erroneous installation of the top link.
Erroneous installation of the top link
1 The upper connection (top link) of the vehicle for the at-
tachment is not correctly installed. The angle to the low-
er mounting deviates too much.
2 If the attachment is raised in this way, this will lead to a
sudden retraction towards the driver cabin and thus to
damaging the windscreen, or other add-on parts.
3 The more the angle deviates from the upper to lower
mounting, the more the attachment will be tilted back-
wards during the lifting process.
Correct installation of the top link
1 The upper connection of the vehicle for the attachment
is correctly installed. The angle of the connection is
much flatter than with an incorrectly installed connec-
tion. This prevents the driver cabin from being damaged
when the attachment is being lifted.

9.3.3 4-point mount (optional)

The 4-point mount is attached to the front power lift and se-
cured with 2 bolts.
It has got one inclination adjustment system.
4-point mount
1
Central locking lever
2
Lower mount
3
Top mount
4
Bolt for inclination adjustment
5
Inclination adjustment
1. Remove the bolt for the inclination function; the attach-
ment is able to swing.
2. If the attachment is completely raised, the device will be
aligned horizontally.

9.3.4 Fitting the attachment on the 4-point mount

WARNING
Risk of injury due to attachments
Do not move or fit any attachments if persons are in the
hazard zone.
1. Drive up to the attachment.
2. Lower the front power lift far enough until the upper cou-
pling points are beneath the mounts for the attachment.
3. Pull the lever for the central lock upwards, and push it to
the right in order to open the lock.
4. Drive up to the attachment until the mounts come into
contact.
5. Cautiously move the front power lift upwards until the at-
tachment is lifted into the mounts and fixed in place.
6. Push the lever on the central lock to the left again; the
lever must engage in the holder in order to lock the at-
tachment.

9.3.5 Detaching the attachment on the 4-point mount

1. Lift the attachment off the ground.
2. Release the central lock.
3. Lower the 4-point mount with front power lift far enough
until the mounts of the attachment are exposed.
4. Drive away from the attachment.
5. Close the lever for the central lock again before the 4-
point mount is raised upwards completely.

9.3.6 Front mounting frames

Certain attachments can be attached directly to the mount-
ing frame for attachments.
Mounting frames
1
1. Push the attachment into the mounting frames and se-
cure using 2 bolts.
9.4

Mounting options at the rear of the vehicle

9.4.1 Attachment frame with tipping function (option)

Possible attachments on the attachment frame: Spreader,
water drum or the grass / leaf vacuum container on a mow-
er / vacuum combination.
English 77