Front Cover; Side Covers; Radiator Protective Grille; Removing / Installing The Battery - Kärcher MIC 50 Handbuch

12.7.3Side covers

Lock for side cover
1
Side cover
2
Removing the side cover:
1 Open both locks.
2 Lift the side cover and pull it out to the side.
Attaching the side cover:
1 Insert the side cover at the side.
2 Mount the side cover at the upper edge and into the fix-
ing slot.
3 Slide the side cover into the correct position and secure
it using the locks.

12.7.4Front cover

Lock for side cover
1
Side cover
2
Lock for front cover
3
Front cover
4
Removing the front cover:
1 Remove both side covers.
2 Open the left and right lock on the front cover.
3 Lift and remove the front cover.
Attaching the front cover:
1 Mount the front cover and fix it in place using both locks.
2 Install both side covers.

12.7.5Radiator protective grille

Removing the radiator protective grille:
1 Lift the radiator protective grille at the top.
2 Move out the lower part
3 Remove the radiator protective grille in a downward di-
rection.
Attaching the radiator protective grille:
1 Engage the radiator protective grille at the bottom, then
snap shut at the top.

12.7.6Removing / installing the battery

DANGER

Danger of injury

Observe the safety regulations on the handling of batter-
ies.
ATTENTION
Disconnect the minus terminal first when removing the bat-
tery.
Protect the battery terminals and terminal clamps with a
sufficient quantity of terminal grease.
Batterie ausbauen

Removing the battery

1. Remove the covering caps from the terminal clamps.
2. Release the terminal clamp (black cable) on the minus
terminal (-).
3. Release the terminal clamp (red cable) on the plus ter-
minal (+).
4. Unscrew the bracket on the battery base.
5. Take the battery out of the battery holder.
1. Fit the battery into the battery holder.
2. Screw the bracket on the battery base tight.
3. Connect the terminal clamp (red cable) to the plus ter-
minal (+).
4. Connect the terminal clamp (black cable) to the minus
terminal (-).
5. Plug the cover caps onto the terminal clamps.

12.7.7Charging the battery

DANGER

Risk of injury

Only charge the battery with a suitable charger.
Observe and follow the instructions for use from the charg-
er manufacturer.
Observe the safety instructions on the handling of batter-
ies.
1. Disconnect the minus terminal at the battery.
English
Installing the battery
85