Lubrication Plan; Preparing For Maintenance Work; Maintenance Work; Raising The Attachment Frame - Kärcher MIC 50 Handbuch

Pos. Assembly
19 Warning sticker
20 Dust caps and covers for hy-
draulics
21 Hoses and cable clamps
22 Fuel lines and connections
23 Bowden cables and moving
parts
24 Alternator
25 Electrical cables
26 Bearings / lubrication points Lubricate, see chapter 12.5 Lubrication
* depending on which occurs first

12.5 Lubrication plan

Lubrication point
1 Central lubricating strip for
 Slew bearing
 Lifting cylinder for front
power lift
 Front bearing for steering
cylinder
2 Articulated joint at centre of
vehicle
3 Steering cylinder
4 Lower bearing for articulated
joint
84
Activity
Check the legibility, replace if necessary.
Check, and replace any missing or dam-
aged ones.
Visual inspection of all hydraulic connec-
tions that they are correctly fitted and
leakproof.
Check for leaks.
Check for freedom of movement.
Clean (not with high-pressure cleaner)
Check for damage.
plan
Quanti- Interval
ty
1 Daily
2 Daily
2 Daily
1 Daily
English
Daily
X
X
Lubrication point
5 Lifting cylinder for lifting plat-
form
6 Slew bearing lifting platform 2
7 Accelerator
8 Brake pedal deflection lever 1
1 Use high-grade multi-purpose grease.
2 Lubricate the grease nipples in accordance with the lu-
bricating intervals (Table) using a grease gun.
3 Keep the V-belt clean and free of grease.

12.6 Preparing for maintenance work

1. Park the vehicle on a level surface.
2. Set the engine speed to idle mode.
3. Switch off the ignition and remove the ignition key.
4. Secure the vehicle against rolling away.
5. Set the main switch to position "0".

12.7 Maintenance work

12.7.1Raising the attachment frame

Note
The raised attachment frame is automatically secured by a
special valve on the vehicle side. It is not necessary to se-
cure it manually.
1. Set the switchover valve to the attachment frame posi-
tion.
2. Completely raise the attachment frame.

12.7.2Panels / covers

WARNING
Risk of burns from hot surfaces
Allow the vehicle to cool down sufficiently prior to removing
the panels / covers.
Note
In order to carry out various maintenance work, the
panels / covers have to be removed.
Weekly every 500
hours
or once-a-year*
X
X
X X
X
X
X
X
Quanti- Interval
ty
4 Every 25 h
Daily
1 Every 100 h
Every 100 h