Danger; Risk Of Burns; Important; Getting Started With The Generating Set - Vario 1000i Benutzer- Und Wartungshandbuch

2.5. Risk of fire

DANGER

2.6. Risk of burns

Never touch the engine or the silencer while the generating set is in operation, or when it has just stopped. Wait
for the engine to cool before carrying out any work (at least 30 minutes).

IMPORTANT

Hot oil burns; avoid contact with the skin. Before carrying out any operation, check that the system is no longer pressurised. Never start
or run the engine if the oil filler cap is off (oil may splash out).
2.7. Guidelines for protecting the environment
Drain the engine oil into a designated container: never drain or discard engine oil onto the ground.
As far as possible, avoid sound reverberating through walls or buildings (the noise will be amplified).
If the generating set is used in wooded, bushy or uncultivated areas and if the exhaust silencer is not fitted with a spark arrester, clear
any vegetation away from the area and take care that the sparks do not cause a fire. Once the generating set is no longer being used
(end of product life), take it to a waste collection point.

3. Getting started with the generating set

3.1. Key to illustrations
The cover illustrations can be used to identify the various components of the generating set. The procedures in the manual refer to
these illustrations using letters and numbers as identifiers, for example, "A–1" refers to the number 1 on figure A.
1 Earth connection
2 Inspection cover
3 Fuel tap
4 Fuel tank aeration pointer
A 5 Fuel tank cap
6 Choke
7 Recoil starter
8 Electrical socket
9 MAX / ECO Mode
1 Inspection trap cover
B
Oil filler and drain plug
2
Maximum oil filling level
1 Air filter cover
D
Filter element
2
Filter element cleaning

3.2. Initial commissioning

On taking delivery of the generating set, check that it is complete and not damaged in any way. If the generating set is equipped with a
transport bracket located on the engine, remove it. Top up the oil (if necessary) and fuel, and connect the battery (if fitted). Never invert
the positive and negative terminals on the battery (if fitted) when connecting it, as this could cause serious damage to the electrical
equipment. Some generating sets require a running in period. Contact your nearest agent for more information.

4. Using the generator set

Before using, it is necessary to understand all of the controls and manoeuvres.
To stop the generating set in an emergency, close the fuel tap.
This generating set is designed for occasional domestic use.
IMPORTANT
RISK OF FIRE
Never operate the generating set in areas containing flammable products (risk of sparks).
Keep all inflammable or explosive materials (petrol, oil, fabric, etc.) out of the way. when
the generating set is operating. Never cover the generating set with any type of material
while it is in operation or just after it has been switched off: always wait until the engine
cools down (at least 30 minutes).
10
11
12
13
14
Tank pressurisation pump
Indicator lamps
A. Operating light
B. Overload indicator
C. Oil safety indicator
12V socket (if fitted)
Spark plug access cover
Muffler
1 Fuel tank aeration pointer
2 Tank pressurisation pump
C Fuel strainer
3
Maximum fuel filling level
4 Fuel filter
1 Spark plug access cover
E
2 Spark plug
O N / O F F
O N / O F F
13