Herunterladen Inhalt Inhalt Diese Seite drucken

Ricerca Inconvenienti - Carrier 38TY Installations-, Bedienungs- Und Wartungsanweisungen

Inhaltsverzeichnis

Werbung

GB
Troubleshooting chart
Symptoms /
REMEDY
The compressor starts and stops:
• Incorrect refrigerant charge.
,
UNLOAD THE REFRIGERANT
CREATE A VACUUM AND
.
FILL AGAIN
• Air or gas in the system which cannot be
condensed.
.
VENT THE SYSTEM
• Defective compressor.
CHECK AND REPLACE THE COMPRESSOR
• Power supply voltage outside the limits
C
HECK AND REMOVE THE CAUSE
• Defective capacitor (single phase unit).
C
HECK AND REMOVE THE CAUSE
• Defective thermostat.
.
REPLACE
• Blocked refrigerant circuit.
,
CHECK
IDENTIFY AND REMOVE THE CAUSE
• Reducer blocked or frozen.
,
UNLOAD THE REFRIGERANT
CREATE A VACUUM AND
FILL AGAIN
The unit runs continually or for a long
time:
• Thermal capacity underestimated.
R
EDUCE THE CAPACITY OR RESET TO A HIGHER
.
DEGREE
• Room thermostat too low.
.
ADJUST
• Low refrigerant charge, leaks.
,
FIND THE LEAK
REPAIR AND TOP
.
REFRIGERANT
• Defective indoor unit.
,
.
CHECK
REPAIR OR REPLACE
High condensation pressure:
• Blocked condenser.
,
CHECK
CLEAN OR REPLACE
• Excessive refrigerant load.
DISCHARGE THE EXCESS
• Air or gas that cannot be condensed in the
system.
,
UNLOAD THE REFRIGERANT
CREATE A VACUUM AND
.
FILL AGAIN
Low pressure:
• Insufficient refrigerant charge, leaks.
CHECK FOR THE PRESENCE OF ANY LEAKS
.
AND FILL AGAIN
High aspiration pressure:
• Excessive refrigerant charge.
.
DISCHARGE THE EXCESS
• Defective reducer.
C
,
.
HECK
REPLACE
Aspiration pressure too low:
• Insufficient refrigerant charge.
CHECK FOR THE PRESENCE OF ANY LEAKS
.
AND FILL AGAIN
32
I

Ricerca inconvenienti

Anomalia
Il compressore si avvia e si ferma :
Carico di refrigerante erroneo.
SCARICARE IL REFRIGERANTE
RIEMPIRE DI NUOVO
Aria o gas incondensabile nel sistema.
SPURGARE IL SISTEMA
Compressore difettoso.
VERIFICARE E SOSTITUIRE IL COMPRESSORE
.
Tensione di alimentazione fuori dai limiti.
VERIFICARE E RIMUOVERE LA CAUSA
.
Capacitatore difettoso (unità monofase).
VERIFICARE E RIMUOVERE LA CAUSA
.
Termostato difettoso.
SOSTITUIRE
Circuito del refrigerante ostruito.
VERIFICARE
.
Riduttore ostruito o congelato.
SCARICARE IL REFRIGERANTE
RIEMPIRE DI NUOVO
L'unità funziona continuamente o per
molto tempo :
Portata termica sottovalutata.
RIDURRE LA PORTATA OPPURE IMPOSTARE
NUOVAMENTE SU UNA MISURA MAGGIORE
Termostato ambiente troppo basso.
CALIBRARE
Carico di refrigerante basso, fughe.
TROVARE LA FUGA
-
UP THE
REFRIGERANTE
Unità interna difettosa.
VERIFICARE
Alta pressione di condensazione:
Condensatore ostruito.
verificare, pulire o sostituire.
Carico di refrigerante eccessivo.
SCARICARE L
Aria o gas incondensabile nel sistema.
SCARICARE IL REFRIGERANTE
RIEMPIRE DI NUOVO
Bassa pressione:
• C
arico di refrigerante insufficiente, fughe.
VERIFICARE L
RIPARARE
,
REPAIR
Alta pressione di aspirazione:
Carico di refrigerante eccessivo.
SCARICARE L
Riduttore difettoso.
VERIFICARE
Pressione di aspirazione troppo bassa:
Carico di refrigerante insufficiente.
VERIFICARE L
RIPARARE
,
REPAIR
/
RIMEDIO
,
CREARE IL VUOTO
.
.
.
.
.
.
,
IDENTIFICARE E RIMUOVERE LA CAUSA
,
CREARE IL VUOTO
.
.
.
,
RIPARARE E RABBOCCARE IL
.
,
.
RIPARARE O SOSTITUIRE
'
.
ECCESSO
,
CREARE IL VUOTO E
.
'
EVENTUALE PRESENZA DI FUGHE
,
.
RIEMPIRE DI NUOVO
'
.
ECCESSO
,
.
SOSTITUIRE
'
EVENTUALE PRESENZA DI FUGHE
,
.
RIEMPIRE DI NUOVO
,
.
,
,
,

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis