Stryker Prime Series Bedienungsanleitung Seite 50

5. Raise the siderails.
6. Place the IV poles and push handles in the up position.
7. Clean the product with a maximum water temperature of 82° C (180° F) and a maximum water pressure of 103.5 bar /
1500 psi.
8. Air dry the product with a maximum temperature of 93° C (240° F) for eight minutes.
9. Dry the product. Do not place the mattress on the product until the product is dry.
10. Check functionality before you return the product to service.
• Raise and lower the product
• Lock and unlock the brake/steer pedal in both positions
• Latch and unlatch the siderails
• Raise and lower the Fowler backrest
• Make sure all components have proper lubrication
• Make sure all labels are intact and legible
N N o o t t e e
• Do not steam clean the product.
• Some cleaning agents are corrosive in nature and may cause damage to the product if you use them improperly. If
you do not rinse and dry the product well, a corrosive residue may be left on the surface of the product that could
cause premature corrosion of critical components. Failure to follow these cleaning instructions may void your
warranty.
C C l l e e a a n n i i n n g g t t h h e e m m a a t t t t r r e e s s s s
W W A A R R N N I I N N G G
• Do not clean, service, or perform maintenance while the product is in use.
• Do not immerse the mattress in cleaning or disinfectant solutions. Excess moisture could cause product malfunction that
results in product damage or patient injury.
• Do not allow fluid to pool on the mattress. Fluids can cause corrosion of components and may cause the safety and
performance of this product to become unpredictable.
• Always inspect mattress covers for tears, punctures, excessive wear, and misaligned zippers every time you clean the
covers. Remove and replace a damaged mattress to prevent cross-contamination.
• Do not steam clean, pressure wash, hose off, or ultrasonically clean mattresses. These methods of cleaning may void
the product's warranty.
The life of the mattress can be affected by an increase in frequency of usage, which might include more frequent cleaning
and disinfection.
Recommended cleaning method:
1. Use a clean, soft cloth to wipe down the entire mattress with a mild soap and water solution to remove foreign material.
2. Wipe down the mattress with a clean, dry cloth to remove any excess liquid or cleaning agents.
3. Rinse and dry covers after cleaning.
4. Disinfect as needed with a hospital grade disinfectant after cleaning has been completed (see Disinfecting the
mattress ).
N N o o t t e e
• Do not iron, dry-clean, or tumble dry the mattress, as this will cause malfunction and damage the product.
• The mattress cover must be completely dry before you store, add linens, or place a patient on the mattress to prevent
impairment of the product performance.
• Avoid over-exposure to alcohol or hydrogen peroxide. The cover material will swell.
EN 46 1105-409-005 Rev E.1