Water Filtering; Setting Filtering Cycles; Boost; Water Heating - Jacuzzi Delfi Bedienung Und Wartung

Relax
Formed of the following colours: blue/orange/sky blue/white;
this sequence relieves stress and encourages relaxation; the or-
ange hue offers warmth in this sequence composed primarily of
"cold" colours.
Stable colours
You can also choose from the following colours, which appear in
stable fashion: white, light blue, orange, yellow, green.

Water filtering

F
iltering, obtained through the combined action of a pump and
a cartridge filter, is indispensable to keep the water clean and
transparent, and to eliminate particles in suspension.
N.B.: some models are equipped with a UV light (Clearray ™), which
helps disinfect and purify the water. When the filtering cycle is start-
ed, the generator starts automatically, and shuts off at the end of
the cycle.
Clearray™ runs automatically and is contingent on the acti-
vation of the pump (at low speed) during the filtering cycle. It
will be off if the hydromassage or even one spotlight is on. This
is because there is probably a person in the tub. Forty (40) min-
utes after the functions are shut off, Clearray™ begins operating
again, provided a filtering cycle is active.
Setting the filtering cycles
To set the filtering cycle:
Press the "Light" key and hold it down for about 5 sec-
onds. The display will show the message dx, where "x" indicates
the duration in hours.
Use the key "Up/Down"
from a minimum of 0 to a maximum of 12 hours.
NOTE: hold the key down until you reach the desired value.
If the display is equipped with two separate keys, press the key
"Up" to increase the value or the key "Down" to decrease it.
to enter the desired duration,
Press the "Light"
value and to continue the programming of the start delay, com-
pared to time "0", of the cycle (parameter sy, where "y" indicates
the number of hours).
ATTENTION: the "0" time is the instant in which the spa is powered
using the main switch. If, for example, the cycle start delay is set to "4",
this means that filtration will start 4 hours after the spa is turned on.
Set the start delay (from a minimum of 9 to a maximum of 23)
using the key "Up/Down"
key to save the entered value and exit from the programming
mode.
When this function is active, the LED of the respective symbol
will turn on. If the LED is blinking, it means that the cycle has been
suspended, see the relative chapter for more information.

"Boost"

This special type of filtering is recommended in special situations,
such as before or after a party with friends, or to facilitate dissolu-
tion of substances used for water disinfection.
To activate this function, press and hold down the "Pump"
key for 5 seconds. The display will show the message boo.
The operation lasts 45 minutes (this time period cannot be
modified) during which time the pump is activated at high speed
along with Clearray™.
For details on filtering, refer to the product's installation
manual.

Water heating

T
he water in the tub is heated by the electric heater located in
the tub compartment. Temperature adjustment is managed
based on specific parameters to be set from the control panel.
25
key once again to confirm the selected
and confirm using the "Light"