Maintenance Of Thermal Cover; Special Maintenance; Draining The Tub; Winter Inactivity - Jacuzzi Delfi Bedienung Und Wartung

4
3

Maintenance of thermal cover

Fabric
Remove the cover from the support frame and lay it on a
straight surface.
Dampen the fabric with clean water.
Evenly spread a diluted solution of neutral soap on the surface.
Let the solution stand for 2-3 minutes, depending on the
degree of dirtiness.
Clean the cover with a soft brush.
To remove all soap residue, rinse with plenty of clean water.
In case of heavy incrustation, repeat the operation.
If necessary, perform the steps above on the back side as well.
Let the cover dry. Then place it on its support until it is per-
fectly dry.
Leatherette
Use a neutral cleaner, then rinse with clean water.
If necessary, use a specific product after cleaning to restore
and maintain the material's shine.

SPECIAL MAINTENANCE

Draining the tub

It is a good rule to empty the spa regularly (about every 4-8 weeks),
in order to ensure a change of water and proceed with tub cleaning.
If you are away for any length of time, it is advisable to empty
the spa, as long periods without carrying out water treatment can
damage the spa.
CAUTION
Before emptying, make sure that the chemical additive
values in the water are within the permitted limits.
If in doubt, contact the local authorities.
DO NOT EMPTY THE WATER INTO A SEPTIC TANK.

Winter inactivity

In areas where winter temperatures frequently drop below 0°C,
during periods in which the spa is not used, proceed as follows:
Turn off the power supply on the main panel.
Completely drain the spa via the drain valve, which is to be
left open, and the possible gate valve installed on the auxiliary
drain (if installed; refer to the pre-installation instructions).
The emptying of the spa is not complete; stagnant water on the
seats and bottom of the tub can be eliminated with a sponge, while
water left in the hoses can be sucked out through the hydromassa-
ge and suction intakes, using a liquid-suction pump. It is advisable
to empty the pump as well via the appropriate drain plug.
IMPORTANT
In cold climates, where temperatures drop well below 0°C,
all residual water should be eliminated from the circuit.
Remove and clean the filter cartridge and store in a dry place.
Cover the spa to keep it clean.
Before you use the spa again, refer to the chapter on opera-
ting checks for first start-up.
In areas where temperatures only occasionally drop below 0 °C,
the spa can be left in operation, since it is equipped with an anti-
freeze protection that ensures that a minimum water temperatu-
re is maintained (see the chapter "Setting water temperature", which
contains paragraphs on maintaining the minimum water temperature
and preventing freezing of water in the pipes - "Smart Winter" mode).
Maintenance of synthetic wood parts
Synthetic wood panels require little maintenance; use a neutral
detergent when cleaning, rinsing with clean water.
CAUTION
Do not use jets of water to clean panels as they may pen-
etrate into the spa technical compartment and cause
damage to the electrical system.
Maintenance of natural wood parts
Some of the Jacuzzi® spa covering panels and accessories are
made of natural wood, treated with advanced products which
enhance the natural beauty and ensure protection against atmos-
pheric agents.
32