Water Filtering; Setting The Filtering Cycles; Adjustment Of Water Temperature - Jacuzzi Skylounge Bedienung Und Wartung

The spot light remains on for 3 hours, but it can be turned off
before this time by holding down the button referred to above.
The colour combinations are regulated in terms of tones and inten-
sity by the built-in digital system.
Cromodream
This cycle allows you to experience the entire colour range - col-
ours appear in complimentary fashion, merging from one colour
to the next, providing complete satisfaction.
Sunlight
A colour trio (yellow/orange/white), with short interspersions of
sky blue and violet, reminiscent of the beneficial effects of solar
light; yellow alternated with violet uplifts mood and improves
general physical balance.
Relax
Formed of the following colours: blue/orange/sky blue/white;
this sequence relieves stress and encourages relaxation; the or-
ange hue offers warmth in this sequence composed primarily of
"cold" colours.
Stable colours
You can also choose from the following colours, which appear in
stable fashion: white, light blue, orange, yellow, green.

Water filtering

Filtering, obtained through the combined action of a pump and a
cartridge filter, is indispensable to keep the water clean and trans-
parent, and to eliminate particles in suspension.
N.B.: some models are equipped with a UV light (Clearray ™), which
helps disinfect and purify the water. When the filtering cycle is start-
ed, the generator starts automatically, and shuts off at the end of
the cycle.
Clearray™ runs automatically and is contingent on the ac-
tivation of the pump (at low speed or the filtering pump, where
present) during the filtering cycle. It will be off if the hydromas-
sage or even one spotlight is on. This is because there is probably
a person in the tub. Forty (40) minutes after the functions are shut
off, Clearray™ begins operating again, provided a filtering cycle
is active.

Setting the filtering cycles

To set the filtering cycle:
Hold down the "Pump"
onds: dx (where "x" indicates the duration in hours) appears on
the screen.
button for approximately 5 sec-
Use the "Up/Down"
(from a minimum of 0 to a maximum of 12 hours).
NOTE: press and hold the button until you reach the desired value;
by releasing the button and pressing it again, the adjustment is
made in the opposite direction. If the screen has two separate but-
tons, press the "Up" button to increase the value or the "Down" but-
ton to decrease it.
Press the "Pump"
confirmed, and the cycle start delay is programmed with re-
spect to the "0" time (sy parameter where "y" indicates the num-
ber of hours).
WARNING: time "0" is the instant when power is supplied to the hot
tub through the main switch or the time when the parameters are
stored; if, for example, the value "4" is set as the start delay of the
cycle, this means that the filtration will start 4 hours after turning
on the hot tub, or after storing the parameters; it is also possible to
reduce the parameter value to 0 "s": In this case, the filtration will
start immediately.
Set the start delay (from a minimum of 0 to a maximum of 12)
using the "Up/Down"
"Pump" button to store the values inserted and to exit the
programming mode.
When the function is active, the LED of the respective symbol
lights up (if it flashes, it means that the cycle has been suspended;
see relative section).
During the filtering cycles, "Flt" appears on the screen.
For details on filtering, refer to the product's installation
manual.

Adjustment of water temperature

The water in the tub is heated by an electric heater; the temperature
is adjusted based on specific parameters, which are set using the
control panel.
It is recommended not to set excessive heating temperatures.
18
button to enter the desired duration
button again and the selected value is
button and confirm the value with the