Abnormal Operating Conditions Alarm Signals; Audio System (Optional) - Jacuzzi Delfi Bedienung Und Wartung

Press the key "Up/Down"
rently memorized temperature, the respective symbol appears
and the LED comes on.
Press the key "Up/Down"
value from a minimum of 15 °C to a maximum of 40 °C (59÷104 °F).
NOTE: if you press the upper part of the key, the displayed value
increases. If you press the lower part, it decreases.
If the display is equipped with two separate keys, press the key
"Up" to increase the value or the key "Down" to decrease it.
To show the temperature of the water in the tub again, do
not touch any key for about 5 seconds.
Maintenance of minimum temperature of water in tub and
anti-freeze protection of the pipes ("Smart Winter").
The system software of your spa is designed to provide efficient,
rational management of any hazardous situations which may oc-
cur due to excessively cold temperatures and freezing of the water.
For further information on water heating and system safeguards,
refer to the product's installation manual.
NOTE: when the anti-freeze protection is active, the display will
show the message ICE.
Abnormal operating conditions
- alarm signals -
A
larms are indicated on the display, with the corresponding error
code. You will continue to see the code if the alarm condition
persists.
Here is a list of the various alarms that may appear. Refer to the
product's installation manual for a detailed description of the vari-
ous messages that may appear on the display.
"FLO"
The heater does not turn on.
- Contact an authorized Jacuzzi® service centre.
: the display will show the cur-
again to change the displayed
"HOH" The measured temperature at the heater is 48 °C (118 °F)
or higher (the heater is turned off).
DO NOT ENTER THE WATER
- If the alarm condition persists, try turning the switch up the line
from the spa off and back on. If the signal stays on, contact an
authorized Jacuzzi® service centre.
"Ho" Excessive water temperature
DO NOT ENTER THE WATER
- If present, remove cover from spa.
- If the excessive temperature increase is due to sunlight, add
cold water to the spa.
When the temperature has dropped to below 43 °C (109 °F), the
spa should re-activate automatically. If it does not, disconnect the
power supply and contact an authorized Jacuzzi® service centre.
"H2O" Water level too low.
It's not possible to activate the pump.
- Fill with water until the message disappear.
"rPF" Defective temperature probe.
DO NOT ENTER THE WATER
It is not possible to activate any function.
- Contact an authorized Jacuzzi® service centre.
"HPF" Activation of safety thermostat.
It is not possible to activate the electric heater.
The electric heater has been deactivated due to overheating. This
may be due to irregular water flow.
- Try turning the switch up the line from the spa off and back
on (system reset). If the signal stays on, contact an authorized
Jacuzzi® service centre.

Audio system (optional)

USE OF THE MP3 PLAYER (not included)
Before you can use the audio system, the MP3 player must be able
to communicate with the Bluetooth® device. You must "connect"
the devices using a process known as "pairing".
Make sure the spa is powered on (display on).
Follow the instructions in the MP3 player manual on how to
perform "pairing".
NOTE: To use the audio system of the spa, select the Bluetooth® de-
vice called BT Jacuzzi". The access code is 0000.
NOTE: The Bluetooth® device of the spa is found on the side where
the control panel is located, at bottom (see figure). It turns on each
time the spa is turned on.
26