Maintenance And Repair - SATA SATAjet 1000 ROB RP/HVLP Betriebsanleitung

Information!
The grub screw
arresting the material flow con-
trol and is permanently glued in
place. (for variants with material
flow control).
■ Adjust material flow rate using
material supply pressure.
■ For low quantities of material fine
adjustment of the material flow rate
is possible by turning the material
flow control [1-6]. (for variants with
material flow control).
Adjustment of the Spray Fan Pattern
■ Use the control to adjust the flat fan
using flat fan air pressure.
■ Use the control to adjust the round
fan using round fan air pressure.
Painting
Information!
When painting use only the quan-
tity of material required for the
work step.
Maintain the necessary spray
distance when painting (see
Chap. 4).
Store or dispose of the material
properly after painting.
■ Adjust required spray distance (see
Chap. 4).
■ Provide for spray air supply and
material supply.
■ Trigger control pulse for painting
operation with control air.
Operating Instructions for SATA ROB Automatic Guns
serves for
[6-1]
Shut off automatic gun
■ Shut off control air.
■ After completion of the painting
operation or if a longer pause in the
painting operation is planned, shut
off flat fan and round fan air after the
material supply and read and follow
the instructions on care and storage
(see Chap. 11).

10. Maintenance and Repair

The chapter below describes main-
tenance and repair for the automat-
ic gun.
Danger!
If the compressed air circuit and
material supply are not discon-
nected before performing main-
tenance work, components can
detach and/or material escape
unexpectedly.
→ Before performing mainte-
nance work, empty automatic
guns, switch off and disconnect
from compressed air circuit and
material supply.
US
419