Care And Storage; Malfunctions - SATA SATAjet 1000 ROB RP/HVLP Betriebsanleitung

■ Insert the paint needle [14-3].
■ Position the spring [14-2].
■ Screw on the end cap [14-1].
■ Screw on the regulation cap (of vari-
ant with material flow control).
■ Adjust the material flow if necessary
(see chapter 9.2).

11. Care and storage

Careful handling together with con-
stant maintenance and care of the
product is necessary to warrant the
functioning of the automatic gun.
Every time after use, always clean
the automatic gun, check its func-
tion and check for leaks.
After cleaning, dry the complete au-
tomatic gun with clean compressed
air.
Warning!
If cleaning work is performed
while the gun is still connected
to the compressed air circuit and
material supply, components can
unexpectedly work loose and
material can leak.
→ Disconnect the automatic gun
from the compressed air circuit
and the material supply before all
kinds of cleaning work.
SATA ROB Automatic Gun Operating Instructions
The use of aggressive cleaning
agents can damage the automat-
ic gun.
→ Do not use aggressive cleaning
agents.
Only use suitable cleaning solu-
tions for cleaning.
→ Use a neutral cleaning solution
with a pH of 6–8.
→ Do not use acids, caustic
solutions, bases, paint strippers,
unsuitable regenerates or other
aggressive cleaning agents.
There is a risk of corrosion if the
automatic gun is submerged in
the cleaning solution.
→ Do not submerge the automatic
gun in cleaning solution.
Incorrect cleaning tools can
damage the holes and impair the
spray fan pattern.
→ Only use the SATA cleaning
brushes.
→ Never use ultrasonic cleaners.

12. Malfunctions

The following table describes mal-
functions together with their causes
and corrective action.
If it is not possible to remedy a
malfunction with the described cor-
rective action, send the automatic
gun to the SATA customer service
department. (For address see
Attention!
EN
109