Inhaltsverzeichnis
Werbung
Clean the appliance
q Cleaning the appliance:
- Remove the mains plug
(or switch OFF or unscrew
mains fuse)
- Clean the appliance
- Insert the mains plug
- Then switch the appliance
ON again
q NEVER use steam or a steam
cleaner to clean the appliance.
The hot steam can damage the
surfaces and the electrical
components.
The electrical safety of the appliance
may be affected.
q To clean the appliance remove
bottles and put them in a safe place.
q Do not enter the appliance when
cleaning it otherwise there is a risk
of it toppling over.
q Cleaning water must NOT drip onto
the control panel or lights. Clean
the whole appliance, except the door
seals, with tepid water and a mild,
lightly disinfectant cleaning agent
(e.g. liquid soap).
Abrasive and acidic cleaning agents
and chemical solvents and polishes
are NOT suitable.
q Wipe the door seal with tepid water
only and then dry thoroughly.
q Clean the lights only with dry
material.
Clean the dust filter
Fig. y
If the dust filter (15) is dirty or FIL shows
in the display (see Fig. v), clean the
dust filter.
This will maintain the performance of
the appliance and conserve energy.
q To clean the filter, pull off the
ventilation grille (14).
q Clean the dust filter (15), slots (16)
and side grilles (17) with a vacuum
cleaner.
q Re insert the ventilation grille (14).
After cleaning press button
FIL goes out (see chapter Function
buttons and displays).
To give the dust filter (15) a thorough
cleaning:
q Remove the dust filter (Fig. U a)
Raise the dust filter gently (15) by the
handle until it disengages and pull
out forwards.
q Clean the dust filter (Fig. y)
Clean the dust filter (15), slots (16)
and side grilles (17) with a vacuum
cleaner.
q Install the dust filter (Fig. U b)
Press the dust filter (15) upwards in
direction A and then tilt in direction B
until it locks in position.
q Re insert the ventilation grille (14).
en
, display
33
Werbung
Inhaltsverzeichnis
