Quick Start; Quick Set-Up - Samson C.control Bedienungsanleitung

Quick Start

QUICK SET-UP

Setting up your C control is a simple procedure, which takes only a few minutes. There are many ways to interface the
C control with various recording set-ups, so take some time to decide which audio devices you want to connect. The
following section shows a simple set-up for a typical recording studio with an analog console and two sets of powered
studio monitors.
Remove all packing materials (save them in case of need for future service) and plug the provided AC adapter in to the
rear AC power inlet, but don't plug the power pack into a wall outlet just yet.
• Set the controls to the following positions:
DESTINATION
SOURCE
OL
+6
MIX 2TK A
0
-6
2TK C
2TK B
-18
-30
L
LEVEL
MIX SWITCH - IN (LED ON)
2TK A SWITCH - OUT (LED OFF)
2TK B SWITCH - OUT (LED OFF)
2TK C SWITCH - OUT (LED OFF)
HEADPHONE VOLUME - 0
CONTROL ROOM VOLUME - 0
CONTROL ROOM SPKR B VOLUME - 0
MUTE SWITCH - OUT (LED OFF)
DIM SWITCH - OUT (LED OFF)
• Connect your mixer's control room outputs, or the main stereo source that you want monitored, to the Left/
Right MIX input jacks on the C control's rear panel. The C control accepts both balanced and unbalanced signals.
Generally, a balanced signal is preferable because it provides better signal-to-noise ratio and reduced extrane-
ous noise. For a detailed wiring guide, see page 17 in this manual.
• Connect the C control's SPEAKER A left and right outputs to the inputs of your main powered monitors. The
SPEAKER A outputs are balanced, however it is possible to use balanced and unbalanced cables. Generally, a bal-
anced signal is preferable because it provides better signal-to-noise ratio and reduced extraneous noise. For a
detailed wiring guide, see page 17 in this manual.
• Connect the C control's SPEAKER B left and right outputs to the inputs of your power amp or powered monitors.
• Plug the C control's power pack into a wall outlet and switch the unit on by pressing the power switch.
• Now, turn on your power amps or powered studio monitors and set the level control to their normal positions.
CONTROL ROOM
0 10
HEADPHONE
VOLUME
0
0 10
VOLUME
SPEAKER A
R
HEADPHONE
TALKBACK
MUTE DIM
10 0
SPK B
TALKBACK
VOLUME
LEVEL
SUB
SPEAKER B SPEAKER C MONO
SPEAKER A SWITCH - IN (LED ON)
SPEAKER B SWITCH - OUT (LED OFF)
SPEAKER C SWITCH - OUT (LED OFF)
TALKBACK LEVEL - O
TALK TO CUE SWITCH - OUT (LED OFF)
TALK TO 2TK SWITCH - OUT (LED OFF)
6
SAMSON
TALK TO
CUE
10
TALK TO
2TK
CONTROL ROOM
MIC
MATRIX