Clock Functions - JUNO JB126D0 Benutzerinformation

CLOCK FUNCTIONS

Clock functions table
Clock function
Time of Day
Duration
End Time
Time Delay
Set + Go
Minute Minder
00:00 Count Up Timer
How to set: Time of Day
After the first connection to the mains, wait
until the display shows
flashes.
1. Press or
2. Press .
3. Press or
4. Press .
The display shows the new time.
To change the time of day press
and again until
How to set: Duration
1. Set a heating function and
temperature.
2. Press again and again until
starts to flash.
3. Press or
Duration.
Application
To show or change the time of day. You can change the
time of day only when the oven is on.
To set how long the oven works.
To set when the oven turns off.
To combine Duration and End Time function.
To turn on the oven with necessary settings with only one
press of the sensor field any time later.
To set a countdown time. This function has no effect on
the operation of the oven. You can set the Minute Minder
at any time and also when the oven is off.
To set the count up, which shows how long the oven
works. It is on immediately when the oven starts to heat.
The Count Up Timer is not turned on if Duration and End
Time are set. This function has no effect on the operation
of the oven.
and 12:00. "12"
to set the hours.
to set the minutes.
again
starts to flash.
to set the minutes for
4. Press or the Duration starts
automatically after 5 seconds.
5. Press or
Duration.
6. Press or the Duration starts
automatically after 5 seconds.
When the set time ends, the signal sounds
for 2 minutes. The display shows flashing
and time setting. The oven turns off.
7. Press a sensor field to stop the signal.
8. Turn off the oven.
How to set: End Time
1. Set a heating function and
temperature.
2. Press again and again until
starts to flash.
3. Press or
and press . First you set the
minutes and then the hours.
to set the hours for
to set the End Time
13