ECOLAB Versatronic Modbus Beschreibung Seite 130

Modbus protocol description
Error codes
187
188
189
190
191
192
193
194
195
Error list: File system processing
200
201
202
203
300
301
302
303
304
305
Error list: File systems
400
401
417102397 Rev. 1-10.2019
Description
Invalid calibration routine
Invalid calibration step
Calibration not permitted
Sensor reports error
Collision in device address range 10 to 19 (reserved address range for Versatronic
ecoLine O-DO)
Collision in device address range 40 to 49 (reserved address range for Versatronic
ecoLine NTU)
Calibration value outside valid limits
Calibration signal has been reset (see chapter "Calibration signals", page 74)
Collision in device address ranges 20 to 39 or 50 to 89 (reserved address range for
membrane-covered sensors from Versatronic with product group numbers 20263x)
Error installing partition manager
Error installing MFS file system
Error uninstalling partition manager
Error uninstalling MFS file system
Parameter is not a config. type
Buffer too small
Function ID not transmitted
The COE transmission is possible only for individual instances
Parameter is not an "Art_P" type
Function index in system IO not transmitted via COE
General errors in the Versatronic file system
General errors in the boot loader file system
30