Error Codes As Integer Feedback Values - ECOLAB Versatronic Modbus Beschreibung

3.8.3

Error codes as integer feedback values

For some longer processes (for example, sending an email or active transmission of
frames as Modbus master), an error code is entered in a result field or event list at the
end. The error codes can be queried at the Modbus addresses starting at 0x19CD.
Ä Chapter 8.2.24 'Modbus error' on page 86.
Error codes for faults on the Versatronic digiLine bus can be found from address 0x1B46.
Ä 'Last error code' on page 96.
Error codes
Error codes
Error list: Program memory management
1
2
3
4
5
6
7
8
9
10
11
12
13
Error list: General input and output
14
15
16
17
18
19
Error list: Keypad and program lock
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
Description
Program cannot be created
Program does not exist
Program cannot be deleted
Section cannot be deleted
Checksum cannot be stored
Checksum cannot be read
Program cannot be copied
Section cannot be copied
Program checksum error
Program pointer tab. checksum error
Program memory end
Section does not exist
Repeat jump marks
Please use the ENTER key to confirm
Invalid number of digits
The entry contains invalid characters
Value outside of limits
Section not programmed correctly
Password error
Keypad is locked
Programming is locked
Write error in the ser. EEprom (Calib)
Hardware error: MANUAL + AUTO locked
Editing during active program inadmissible
Copying during active program inadmissible
MANUAL is inadmissible during AUTO lead time
Section change! Image update needed
No DB number, image update from PLC
No DB number for process values from PLC
Printer busy or not ready
Setpoint value 1 not programmed
Set up printer (config. / interface)
Possible only when device in MANUAL mode
Autotuning already running
Time axis elapsed or not programmed
Time axis cannot be copied
Time axis does not exist
Program change is locked
MANUAL operation is locked
Program start is locked
27
Modbus protocol description
417102397 Rev. 1-10.2019