Troubleshooting And Remedies - CookMax SV250SP Handbuch

TROUBLESHOOTING AND REMEDIES

The table below indicates the most common problems that may arise during slicing and the necessary
remedies.
PROBLEM
The machine does not start when
the white or green button is
pressed
The machine does not start when
the white or green button is
pressed
The machine does not start, and
there is continuous noise like a
buzz (only in the
machines equipped with three-
phase motors)
When the white or green button is
pressed, the machine stats, but
the white functioning light is not on
The machine starts, but there are
vibrations. The motor is very hot
and there is a bad smell
Under strain, the machine slows
down or comes to a stop
Excessive resistance to product
slicing
The slices are ragged and/or
shaped irregularly
The slices are ragged and/or
shaped irregularly
Unsatisfactory blade sharpening
The product tray does not slide
When the black or red button is
pressed, the machine does not
stop
Unusual noise of trasmission
POSSIBLE CAUSE
No power supply
Defective electrical control
circuit
The motor is running on single-
phase mode
case of
Defective indicator
Defective motor or transmission
Defective transmission
The blade is blunt
The blade is blunt
The blade is excessively worn
out
Worn wheels
Guides
lubricated
Defective electrical control circuit
Loosen belt
are insufficiently
15
REMEDY
Ascertain that the
correctly inserted
Call technical assistance
Press the black or red button
immediately and have
power supply cord and the
circuits upstream verified by
qualified personnel
Do not use the machine when
the pilot lamp is not on; call
technical assistance
Do no use the machine, call
technical assistance
Call technical assistance
Sharpen the blade
Sharpen the blade
Call technical assistance
Replace the wheels;
technical assistance
Lubricate
Stop the machine, unplug from
mains and call
assistance
Adjust belt tension
plug is
the
call
technical