General Information; Limits Of Use - Safety Norms; General Safety Regulations; Manufacturer's Warranty And Liability - CookMax SV250SP Handbuch

GENERAL INFORMATION

LIMITS OF USE – SAFETY NORMS
These machine were designed and built to slice foodstuff in compliance to the norms of the CE
2006/95/EEC, 2006/42/EEC, 2004/108CE, and to the following regulations EN1974, EN60204-1, EN1672-2.

GENERAL SAFETY REGULATIONS

The slicers must be used only by suitably trained personnel. Furthermore, this personnel must have read this
manual carefully.
In particular, please comply to the following instructions:
• install the machine according to the instructions contained in the "Installation" section;
• do not remove the transparent protections, do not modify nor exclude the mechanical and electrical safety
devices;
• in case of anomalies, defective operation, incorrect movement, unusual noise, etc stop
immediately;
• before cleaning or servicing, disconnect the machine from the mains;
• always use scratch-proof and non-slip gloves during cleaning or maintenance;
• lay or remove the goods to be sliced on the sliding plate only when the latter is completely pushed back
and the thickness control knob positioned to 0;
• to move the carriage tray when slicing, use the handle or the product grip handle;
• for extraordinary maintenance (to replace the sharpener wheels, the blade, or others) please contact the
manufacturer or qualified and duly authorized personnel.
The slicers are equipped with a ventilated motor.

MANUFACTURER'S WARRANTY AND LIABILITY

The manufacturer's warranty covering the good functioning of the machines and their compliance to the
service for which they have been designed depends on the correct application of the instructions contained
in this manual.
The Manufacturer assumes no liability either direct or indirect deriving from:
• failure to comply with the instructions contained in this manual;
• use of the machine by personnel who has not read or fully understood the content of this manual;
• use not complying to the specific norms currently applicable in the country of installation;
• unauthorized modifications and/or repairs;
• use of not original accessories or spare parts;
• exceptional events.
PLATES – CONFORMITY MARKS
The machines are produced in conformity with the European Directives in force and their subsequent
amendments. All the parts making the machine meet the terms of the Directive and the CE marks
have been applied to substantiate this compliance.
The plate carrying the Manufacturer's data, the machine data and the CE mark are applied onto the machine
base under the blade guard tie-rod knob.
10
the machine