Precautions - ConMed Linvatec VP4726 Bedienungsanleitung

1.2.2

Precautions

1. United States Federal law
restricts sale of this device to or
on the order of a physician.
2. The monitor should only be used in
compliance with its intended use.
3. Do not use the monitor with incompatible
equipment not authorized by
Linvatec. Doing so may void certifications
and/or warranties.
4. The warranty becomes void and the
manufacturer is not liable for direct or
resulting damage if:
• The monitor or the accessories are
improperly used, prepared or maintained;
• The instructions in the manual are not
adhered to;
• Non-authorized persons open and / or
perform repairs, adjustments or
alterations to the monitor;
NOTE: Receipt of technical documentation
from the manufacturer does not authorize
individuals to perform repairs, adjustments,
or alterations to the monitor or accessories.
Only authorized service personnel may
perform repairs, adjustments or alterations on
the monitor and accessories. Any violation will
void the manufacturer's warranty. Authorized
service technicians are trained and certified
only by the manufacturer.
5. Prior to each use the monitor and all
associated equipment must be inspected for
proper operation.
Rx ONLY 6. Do not expose the monitor to moisture,
operate in wet areas, or place liquids on or
above unit.
7. Electrical cords and attaching cables used
with the monitor must be appropriate for the
rated voltage and current, and in compliance
with all international, national, and local
ConMed
electrical codes and regulations pertaining to
the use of medical devices.
8. Ensure that the available mains voltage
matches the mains voltage data on the rear
of the monitor which is located near the
appliance inlet module.
9. Do not excessively bend or kink the
instrument power cord.
10. Handle all equipment carefully. If the
monitor is dropped or otherwise damaged,
return it immediately for service.
11. Openings in the monitor cabinet are
provided for ventilation. To prevent
overheating, these openings should not be
blocked or covered.
12. Thoroughly clean the monitor as needed
(reference
page E-34).
E-3
"2.3 Cleaning Instructions"
E
on