ConMed Linvatec VP4726 Bedienungsanleitung Seite 46

WARNINGS:
E
1. Portable and mobile RF communications equipment can affect Medical Electrical
Equipment.
2. Use of accessories, transducers, and cables other than those specified, with the exception of
transducers and cables sold by the manufacturer of the equipment as replacement parts for
internal components, may result in increased emissions and decreased immunity of the
equipment or system.
3. The console should not be used adjacent to or stacked with other equipment, and that if
adjacent or stacked use is necessary, the equipment or system should be observed to verify
normal operation in the configuration in which it is intended to be used.
4. Under extreme conditions of primary power voltage sag [Primary voltage less than 60% of
mains] the device may require operator intervention to recover lost image. Device may have
to be restarted by pressing On/Standby Switch.
Table 3: Guidance and Manufacturer's Declaration - Electromagnetic Immunity
The ConMed Linvatec
electromagnetic environment specified below. The customer or the user of the
Emissions Test
RF Emissions
CISPR 11
RF Emissions
CISPR 11
Harmonic Emissions
IEC 61000-3-2
Voltage fluctuations
/ flicker emissions
IEC 61000-3-3
VP47XX and
VP47XXF Monitor should assure it is used in such an environment.
Compliance
Group 1
Class B
Class D
Complies
VP47XXF Monitors are intended for use in the
Electromagnetic environment - guidance
The VP47XX and VP47XXF
energy only for its internal function. Therefore, its
RF emissions are very low and are not likely to cause
any interference in nearby electronic equipment.
The VP47XX and VP47XXF
for use in all establishments, including domestic
establishments and those directly connected to the
public low-voltage power supply network that
supplies buildings used for domestic purposes.
E-42
VP47XX /
Monitors use RF
Monitors are suitable