Remote Control (Option) - Dibo IBH 1.780.020 Gebrauchsanweisung

4.3. Remote control (option)

The remote control is optional on all versions. There are 2 possible versions of the remote control:
- Burner switch (white) & on/off push- button with lamp (remote control 1).
- Burner switch (white) & on/off switch (red) with LED (remote control 2).
The burner switch (white) switches on/off the burner on a distance and has to positions:
Turn to the right (1): burner on.
Turn to the left (0): burner off.
The on/off switch (red) switches on/off the cleaner on a distance and has to positions:
Turn to the right (1): machine on, LED on.
Turn to the left (0): machine off, LED off.
The on/off push- button (with LED) switches on/off the cleaner at desired distance.
The remote control is not equipped with a cable! The type of cable has to be the next: 7x0.75 mm² or 7x1.5 mm²
and can be maximum 50 m long. This to hold down the tension drop over the distance.
Remote control 1
Settings (remote control 1)
When one pushes the reset button during 5 seconds, it is possible to browse through menu on the screen of the
cleaner. One can select these commands now: 'remote control and delay time of remote control'(see beneath).
Remote control:
By selecting this command one can choose if you want to use/use not the remote control.
Remark: when one uses the remote control , you can not use the cold water button and hot water button (see 4.2
page 57) on the display of the cleaner. The other buttons on the display are still available.
Delay time of remote control:
With this command it is possible to regulate the time how long the remote control / cleaner needs to be active
(through the + and - buttons). When the regulated time is exceeded the remote control will turn off, also the lamp
of the on/off push- button will not shine anymore. So the cleaner switches over to a not- active mode.
One can operate back the remote control by pushing the on/off push- button (< delay time) (the lamp of on/off but-
ton shall shine again). The cleaner becomes active again.
As long as the lamp shines, one can simply work further with the cleaner.
When the spray pistol isn't been used during a short time, the remote control shall not fail but remain in a safe
mode (lamp keeps shining), when you push the spray pistol you can work further again.
Just when the delay time is elapsed, the cleaner will fall out fully. The delay time starts running when you loosen
the spray pistol and will be reset again when one sprays longer than 10 seconds.
At a possible disturbance, the lamp of the on/off push- button will flicker.
Check the operating panel of the cleaner to see the fault message and to repair it.
The lamp shall stop flicker when the fault on the operating panel is solved.
Remote control 2
DiBO n.v. 66