Remote Control (Option) - Dibo IBH series Bedienungsanleitung

• Dosage softener:
If one select the command 'water softener' in the menu by pushing on the hot
water button is it possible to adjust the desired dosage. The possible
adjustments are: normal, high, low or no dosage. These can be selected by
pushing via the '+' and '-' buttons till the desired dosage is founded and confirm
than with the warm water button. push on the reset button to go back. Even
here this remark is valid: the machine will return on the last adjusted value.
• Software version:
If you select this path in the menu you can look which software version is
consulted in the cleaner.
2 M A I N S W I TC H
The main switch is mounted centrally on the serving panel and has a red colour
with a yellow border. The main switch has two positions:
• 0: oFF - stop
• 1: on- Start (working position)
3 P R E S S U R E R E G U L ATO R
The pressure regulator is mounted at the right on top of the operating panel.
on the pressure regulator is a turning button, which can adjust the spray
pressure infinitely variable. Turning the button to the right is a higher pressure
(+). Turning the button to left is a lower pressure (-). The pressure can only be
adjusted if the spray gun is served.

REMOTE CONTROL (OPTION)

The remote control is optional on all versions. There are 2 possible versions of
the remote control:
• Burner switch (white) & on/off push- button with lamp (remote control 1).
• Burner switch (white) & on/off switch (red) with lED (remote control 2).
The burner switch (white) switches on/off the burner on a distance and has to
positions:
• Turn to the right (1): burner on.
• Turn to the left (0): burner off.
The on/off switch (red) switches on/off the cleaner on a distance and has to
positions:
• Turn to the right (1): machine on, lED on.
• Turn to the left (0): machine off, lED off.
The on/off push- button (with lED) switches on/off the cleaner at desired
distance. The remote control is not equipped with a cable! The type of cable
has to be the next: 7x0.75 mm² or 7x1.5 mm² and can be maximum 50 m long.
This to hold down the tension drop over the distance.
DiBO 21
E N
o p E R aT I o n