Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3.4. Set to work

Put the high pressure cleaner as much as possible at horizontally position. Connect the water supply.
Connect the spray gun with the high pressure hose (without spray lance) to the high pressure cleaner.
Connect the high pressure cleaner electrically (plug in socket).
Turn the main switch to position 1=ON. Aim the spray gun in to the free space and serve the spray gun until the
water jet is completely de aerated (+- 30 sec.). Turn the main switch to position 0=OFF.
Connect the spray lance to the spray gun. Turn the main switch to position 1=ON.
Serve the spray gun and check the working pressure on the pressure gauge.
Adjust, if necessary, the pressure regulator for the desired spray pressure. For the use of hot water one must turn
the burner switch to the right, position when the burner is on duty at ECO version.
The LED element will lit constantly inside the burner switch if the machine is powered on. At occurance of a pos-
sible fault , the LED will flash xx number of times (according type of error see 4.6 - disturbances) with a pause time
of 2.5 seconds.
Adjust at use of hot water the temperature regulating button tot the desired position at ECO version.
At FULL version one needs to push the buttons near the display to choose if one goes to clean with hot water or
not. At the FULL version you can set this also through the display and buttons.
Pay attention for sufficient fuel in the fuel tank.
Adjusting the concentration from the added chemical products by opening the mixing tap to your needs.
To adjust the desired product (internal/external tank) you have to turn the mixer tap to the right or left.
Fill, if necessary, the softener tank with softener liquid.
Pay attention at a cold start from the cleaner: in some cases it could be that the automat breaks down in the elec-
trical cabinet (only with 11 KW motors). This depends from the situation of the electrical installation on the spot.
So it's recommended to use a fuse with characteristic D.
DiBO n.v. 62

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis