Service; General; Maintenance Diagram; Periodic Maintenance - Dibo IBH 1.780.020 Gebrauchsanweisung

6. Service

6.1. General

All maintenance activities must happen at an disconnected machine and hoses without pressure.
Checking the electric components can happen exclusively by an expert.
Exclusively accessories and replacement components which have been approved by the manufacturer can be
used.
Directly after the activities all securities- and protection parts must be assembled, before the machine is put in
functioning.
"a golden rule" that contributes to a perfectly working machine with few problems, is well the following:
A DAILY CONTROL AND CLEANING OF THE MACHINE FREQUENTLY DO WONDERS!
To be able to guarantee a perfectly working system, one has first necessary a reliable and technical well consid-
ered machine, which is then faced secondly at regular times with a thorough maintenance.
Therefore the experience and the "know-how" of DiBO a technical good working machine is insured and large
maintenance turns can be carried out by experienced DiBO technicians by means of appointment or maintenance
contract, we can suppose in advance that it is satisfied to these two points.

6.2. Maintenance diagram

6.2.1 General
The user can carry out only those actions for which in this book authorisation are given. Each other act has
been prohibited!

6.2.2. Periodic maintenance

- Control of the electric cables, high and low pressure
hoses and coupling and control of the oil level.
- Refreshing pump oil.
- Cleaning water filter.
- Replacement fuel filters.
- Cleaning fuel tanks.
- All following refreshments of pump oil and services.
- Extra control/replacement of joints, valves, o- rings
by acknowledged DiBO- technicians.

6.2.3. Control of oil level / refreshing of pump oil

Check for each use of the machine the oil via the oil level glass or with the oil level bar. Oil must stand right
with the sign of the oil level bar, if the this case is not, oil tops up until the sign. If oil looks forward to there
milky, consult directly the DiBO technicians. To refresh oil, as follows work goes:
- Unbolt the drain plug below the pump.
- Unbolt the tap with the oil level bar. Catch all oil in a barge and remove oil.
- Force up the drain plug there and top up the oil in the breach to the upper part to the exact level.
- Force up the tap with the oil level bar there.
- Recommended oil: 1.836.042
6.2.4. Cleaning of the water filters
Clean the water filters regular and remove possible dirt.
6.2.5. Cleaning fuel filter and -tank
Dismantle the fuel filter, and replace. Empty the fuel tank.
Take care for tightened fuel hoses (clamps on the conduits!) to the fuel filter at a replacement!
Remove the drain plug and catch possible dirt in a barge.
Rinse the tank with a little bit off clean fuel and unbolt the drain plug.

6.2.6. Cleaning of internal chemical tank

At the internal tank one has to clean the tank with high pressure water.
Don't forget to uncouple the drain plug to remove the dirty water with chemicals out of the tank.
Rinse (if necessary) and remove the dirty water back out of the tank.
First 50 hours, each following 200 hours.
First 50 hours, each following 200 hours.
DiBO n.v. 69
After each use.
First 50 hours.
Each 50 hours/every month.
Each 200 hours/half yearly.
Each 600 hours.