Components Review - Dibo IBH 1.780.020 Gebrauchsanweisung

3.3. Components review

1. Motor
The type of motor depends on the type of machine (see technical data).
2. Burner
The type of burner depends on the type of cleaner. The 'green burner' is a burner that makes a higher efficiency.
The burner provides hot water. The temperature of the water is adjustable. The burner is double walled.
The outside wall is air cooled by the ventilator lateral on the burner chamber. On top of the burner one can find
the burner mouth. The water supply and outlet are both situated at the bottom of the burner.
Lime scale deposits while working at higher temperatures
The hardness of the water is possible expressed in French degrees (°F) or German degrees (°D).
The difference is noticeable in the following equation: 1 ° F = 0.56 ° D.
For example, water having a hardness of 40 ° F has a German hardness of 40 x 0.56 = 22.4 ° D.
See the in your area prescribed hardness of drinking water. Hard water can cause problems by means of lime
scale from 30°F or 17°D. When hardened water is now warmed / heated / or being pumped (or when hard water
comes in contact with air), this can cause calcification. Hard water is caused mainly by the presence of two com-
ponents: calcium and magnesium. So the harder the water, the more chances on lime scale! When cleaning with
high temperatures (or at using heated water), you obtain thus faster calcification in case of a low hardness!
This can therefore result in loss of energy efficiency, higher energy consumption and reduced capacity of water
supply (including calcium deposits on the burner coil and other water connection parts).
We, DIBO NV, therefore recommend to decalcify the machines with a burner preventive additionally and after use
of hot water rinse adequate with cold water (if possible) to ensure optimum performance of the machine!
Pay attention on the turning direction of the motor: if the burner does not ignite at first start it is possible that
the turning direction has to be changed (changing the line wires).
These works should be carried out by suitable qualified personnel.
Contact your DiBO dealer in order to carry out these activities.
3. High pressure pump
The type of high pressure pump depends on the type of machine (see technical data).
4. Plug/socket
The implementation of the plug/socket is country dependent. The machine is provided from the factory without
plug. The DiBO dispenser will install the correct plug for delivery.
5. Spraying tools
The high pressure hose must be coupled turnable to the spray gun.
Mount (tighten) also the spray lance to the spray gun.
Because of that you have a great extend of free movement during spraying.
The high pressure spray gun has been carried out with a grey handle.
Not spraying: release the lever in the handle.
Spraying: pressing the lever in the handle.
Spray security: slap the block system out in the lever.
The machine is standard provided with a single lance.
Check during spraying activities regularly if the lance coupling is fixed tightly on the spray gun.
At use of reel(s) (optionally): always unroll the reel hose(s) completely during spraying activities to ensure an opti-
mal performance!
Please note for possible risk of heat to the high pressure coupling of the reel(s) at use of the burner.
DiBO n.v. 60