Turn Off; General; External - Internal Chemical Tank; Lance And Gun - Dibo IBH 1.780.020 Gebrauchsanweisung

5. Turn off

5.1. General

Put the main switch on OFF when you finish the works.

5.2. External - internal chemical tank

Pull the sucking hose out of the chemical tank and hang it in a bucket with clean water.
Seal the internal/external chemical tank with a cap.
Rinse everything, to remove chemicals out off the hoses, lance and pistol.
At a change of EVERY chemical product you have to rinse the tank again with clean water!

5.3. Lance and gun

Serve the spray gun till there's no pressure any more present in the conduits.
Uncouple the lance and put it away. Close the water supply.
Roll up the high and low pressure hoses.

5.4. Water outlet

See chapter 1 - safety and 2.1.2.

5.5. Put away machine

Drain off the water from the supply tank.If necessary, clean the water filter(s).
Slightly clean the cleaner with a tissue. Close the protection cover.
Hold the manual and the ignition keys within arm's reach.
Store the cleaner in a dry and frost free place at a horizontal and stable subsoil.
Press the wheel clip protections (brakes) on the swivel castors.
5.6. Environmentally safe disposal of used fluids
No fluids (anti-scale product, oil, petrol, diesel, softener, ...) may be disposed randomly because of the environ-
ment! So make sure, if you are user, that the applicable local guidelines for environmentally friendly disposal of
these fluids (without soil pollution) are complied.

5.7. Transport

5.7.1. General
Pay attention at transport to the following:
Keeps the machine as much as possible horizontal during transport, one prevents that there leaks oil from the
pump. Load the machine using a lift truck, hydraulic loading platform or a hoist.
Lash the machines (if necessary) sound fixed on the loading platform.

5.7.2. Transportation at frost

Replace the water sucking hose by a short piece hose and hang it with his end in the anti-frost, so the ma-
chine can suck the anti frost. Take the lance from the gun and operate the machine.
Spray until there comes anti-frost out of the gun. The machine is now filled with anti-frost, stop the machine.
Tip: Because the catch of the outgoing anti-frost water, this can be re-used afterwards.

5.8. Burner cooling

If the cleaner is used with hot water, it is essential to turn off the boiler and circulate cold water until the water
output has reached an ambient room temperature, to prevent or minimize limescale deposits in the circuit.
DiBO n.v. 68