Malfunctions - Auping Ultimate Climate Gebrauchsanweisung

9. Malfunctions

The mattress heating operates on 27 Volt low-
voltage current and is protected against over-
heating. A malfunction may be a nuisance but
it is never dangerous.
Nothing appears in the display
It may be that the Ultimate Climate (Advanced)
has not been connected correctly. Check that
the mains voltage and plugs are properly
connected.
The foot zone remains cold during drying
This is not a malfunction. The foot zone always
remains cold during the heating process.
The four outer pilot lights in the display are
blinking intermittently
When the software discovers a fault this is
indicated by the blinking of the four outer pilot
lights and a text will appear in the display of
the Ultimate Climate Advanced.
There are two possibilities.
1. The mattress is cold/fails to warm up.
The text ERROR! CHECK MATTR. CONNECTORS
will appear in the display.
The coupling beneath the mattress may be
making poor or no contact. It could be that the
coupling came loose while the bed was being
made or the bed is in the sitting position while
no one is sitting on it (this could also make the
coupling become detached).
The plug between the topper (inlay) and the
support layer could have come loose (see also
the Installation guidelines).
Solution: Adjust the bed to the flat position and
make sure that there is no sheet between the
mattress conncectors. Position the mattress
precisely in the middle of the mesh base and
press the couplings together until you hear a
click. Also check the plugs beneath the
mattress cover in the mattress.
GB42
2232 BinnenW.pdf - pag.42
2. The mattress is too hot.
The text ERROR! SEE USER GUIDE will appear
in the display.
Possibly the thermal safeguard has been
activated. This could be the case if you have
left the bed in the sitting position or if a pile of
washing has been left on the bed so that the
mattress is unable to release the heat during
the drying process.
Solution: Adjust the bed to the flat position.
Clear the mattress and allow it to cool off. The
heating will be automatically activated when
the correct temperature is reached.
Power cut (Ultimate Climate Advanced)
In the event of a power cut or if the plug is
pulled out, the current time will continue to
activate the program for about thirty minutes.
If the interruption lasts longer the time must
be re-set (see Chapter 5.1.1: Setting current
time). The other settings remain as they were.
If you have any doubts contact your dealer.
LET OP !!! Lage resolutie!
August 11, 2006