Foot Zone Heating Control; Drying - Auping Ultimate Climate Gebrauchsanweisung

4.2 Foot zone heating control

fig. 8
C
G
fig. 9
Setting the heating level
The heating level can be adjusted with the –
and + buttons C and D.
The pilot lights at the bottom indicate the set
level.
The maximum heating time is limited to 12
hours.
Press button (E)
You must keep the pushbutton pressed down
for 3 seconds until the
pushbutton is on.
GB30
2232 BinnenW.pdf - pag.30
after you get up.
the red light of the
LET OP !!! Lage resolutie!

4.3 Drying

D
The body zone (H) will be heated at the highest
setting for a period of 2 hours and forty-five
minutes. The drying cycle stops automatically.
You can stop the drying process sooner by
again pressing the pushbutton
The drying function is explicitly NOT intended
as a bed warming or heating function. During
the drying function, you must NOT lie down or
sleep on the mattress.
At the end of the drying period, the complete
heating system will switch off automatically.
E
H
.
August 11, 2006
fig. 10
fig. 11